Pulsed 910nm laser sources based on tunnel-coupled AlGaAs/InGaAs/GaAs heterostructures have been developed and studied. To provide the maximum brightness and operation in the linear part of the light-current characteristic, a microarray design was developed. This design includes $3\times 800$ - $\mu \text{m}$ -wide stripes in the emitting region. It was demonstrated that, under pumping with 760 A/100 ns current pulses, laser pulse with peak power of 1150 W can be generated. Raising the working temperature led to an insignificant deterioration of emission characteristics, which was manifested by the peak powers of 1030 W/750 A/50°C and 905 W/720 A/75°C.
The results of studying single laser diodes and arrays in the spectral range of 900–1060 nm, fabricated based on InGaAs/AlGaAs epitaxially integrated heterostructures are presented. It is shown that the use of InGaAs/AlGaAs epitaxially integrated heterostructures allows the development of laser emitters with increased power and brightness, operating in the short pulse mode. The results of studying the characteristics of laser-diode arrays (LDAs) fabricated using these heterostructures are presented.
Scanning spreading resistance microscopy (SSRM) was used to study the spatial distribution of carrier concentration in an InGaAs/AlGaAs quantum well laser heterostructure. An analysis of the dependence of current contrast on the polarity of the applied dc bias showed that measurements should be performed at both positive and negative biases above the threshold voltage to visualize all layers of the structure. The actual position of the p–n junction can be determined by finding the point on the averaged SSRM profiles where the current signal is zero. Mathematical modeling of band diagrams and current–voltage (I–V) characteristics of p+-diamond–AlGaAs heterojunctions has shown that, regardless of the AlGaAs conductivity type, the current in the tip contact with the layers of the structure is determined not only by the layers’ conductivity but also by the height of the barrier for holes in the valence band. SSRM can be used as an effective diagnostic tool for the rapid assessment of the conductive properties of laser heterostructures, complementing other traditional analysis methods such as electrochemical capacitance–voltage profiling and secondary ion mass spectrometry.