1 December 2020 in Bragantia
1 January 2024 in Brazilian Journal of Biology
The exploitation of plant genetic resources is an important and rapid strategy to release commercial cultivars. In this study, 234 sour cherry genotypes were collected from various locations of Iran and phenotypically assessed according to IPGRI and UPOV descriptors. The genotypes were grafted onto Mahaleb rootstock and were planted in Horticultural Science Research Institute (HSRI) core collection in Karaj, Iran. In this study, 22 different characteristics were measured in the sour cherry genotypes. The results showed that fruit and stone weights varied from 1.65 (G410) to 5.47 g (G125) and 0.13 (G428) to 0.59 g (G149), respectively. The fruit size index comprised average fruit length, width, and diameter, which varied from 10.57 to 19.13. The stalk length was less than 50 mm in 90.6% of the studied genotypes. Twelve of the 234 studied genotypes did not exhibit any symptoms of bacterial canker disease. Principle component analysis (PCA) and cluster analysis classified the studied genotypes into four main groups. Spearman’s correlation analysis revealed that fruit size, stone shape, stone size, stalk thickness and weight, and fruit appearance correlated positively with stone and fruit weights. In contrast, fruit juice, fruit skin, and flesh color correlated negatively with the stone and fruit weights. The range of TSS varied between 12.66 (G251) and 26 (G427). Variations in pH value were between 3.66 (G236) and 5.63 (G352). In conclusion, a high level of genetic diversity was observed among the Iranian sour cherry genotypes. This diversity can be considered valuable and applicable for future breeding programs.
8 August 2017 in Canadian Metallurgical Quarterly
Sintering process was performed on cylindrical consolidates in dry nitrogen atmosphere at various temperatures ranging from the solidus-to-liquidus temperatures for 30 min at a heating rate of 10°C min−1. Beam bending technique has been used to measure the macroscopic apparent viscosity of Al-Cu-Mg pre-alloyed powder (2024 Al alloy). Slumping test has been used to measure the yield strength at temperatures above solidus temperature. Wetting angle and capillary stress were calculated. Results showed that the rheological behaviour of this system follows as Bingham model. The yield stress varies from 0.37 kPa at 580°C to 0.3 kPa at 610°C on air atomised Al-Cu-Mg having 0.1% Sn. The correlation between variations of viscosity as function of temperature has been derived. The activation energy of viscous flow was estimated to 15.164 kJ mol−1. Capillary and yield stress decrease by increasing temperature. Maximum densification with minimum distortion is obtained at 600–610°C.
11 September 2024 in Plant Genetic Resources: Characterization and Utilization
Preservation of the genetic diversity of sour cherry in Iran is imperative for the development of improved cultivars tailored to specific ecological conditions. Addressing gaps in research concerning ecological adaptation, resource management and international collaboration related to sour cherry genetic resources in Iran is essential. Bridging these research lacunae can facilitate the implementation of sustainable cultivation practices, optimize production systems and enhance the global utilization of sour cherry genetic diversity. A comprehensive analysis of the morphology and ultrastructure of pollen grains from ten native sour cherry genotypes in Iran was conducted over a two-year period using scanning electron microscopy (SEM). The examination revealed that all pollen grains were unipolar, radially symmetrical and tricolpate. The length and width of pollen grains varied among genotypes, with lengths ranging from 42.17 to 57.57 μm and widths from 20.28 to 28.13 μm. Furthermore, all genotypes exhibited prolate pollen grains, with differing colpus lengths. Examination of pollen exine revealed striate shapes with varying numbers of ridges, ranging from 18.5 to 8.5 furrows per 50 m2. The horizontal area of pollen grains varied from 333.28 to 1491.69 μm. Polar perspective analysis showed considerable variation in the distance between mesocolpium endpoints. Sour cherry displays significant genetic diversity in Iran, and the application of SEM has proven instrumental in characterizing this diversity. This understanding will aid in further breeding research aimed at enhancing sour cherry varieties and their adaptation to specific ecological conditions.
1 May 2023 in Journal of Welding Science and Technology of Iran IWNT
This study aimed to investigate the effect of electron beam welding parameters on the microstructural characteristics and mechanical properties of the dissimilar joint between 17-4PH stainless steel and Ti6Al4V alloy. For this purpose, the welding of these two alloys was performed with an copper interlayer with a thickness of 1 mm. Two ...