Based on the equivalent circuit model (ECM), it is demonstrated that five resonances can occur within the absorption band of a circuit analog (CA) absorber containing two lossy layers. The lossy layers are composed of resistor-loaded square-loop and double-square-loop arrays. In the absence of a dielectric skin, an initial design with four resonances observed from its reflectivity exhibits a simulated bandwidth ratio (BWR) of 1:8.45 for at least 10 dB absorption. To facilitate physical implementation of the wideband absorber, a modified design is proposed to compensate the effect of parasitic parameters of actual resistors on reflectivity. It is shown through measurement that an operating BWR of 1:8.78 is achieved with the reflectivity smaller than μ10 dB under normal incidence. The total thickness of the absorber prototype is only 0.096 λ at the lowest operating frequency. The agreement between simulation and measurement validates the proposed design.
Multilayered frequency-selective structures with checkerboard arrangement are presented to demonstrate the application of passive phase cancellation to reduce the strong reflection from a traditional two-dimensional single-layer slot-type frequency-selective surface. The simple square slot is used as the basic unit to construct the involved supercells which are further combined to achieve the multilayered structures. The properly selected spacing between layers is mainly responsible for producing supercells with out-of-phase reflections, which establishes the destructive interference of reflected waves. In comparison with the traditional frequency-selective surface, a band of reflection reduction is observed below the passband through the principle of phase cancellation. Meanwhile, the multilayered structures can maintain a passband with small insertion loss for transmission. The effect of increased supercell types on the bandwidth enhancement of reflection reduction and that of checkerboard arrangement on the angular performance are considered. The good agreement between simulation and measurement validates the observations.
Accurate simulation of the failure process of hard brittle surrounding rockmass is very important for the analysis and control of the structural stability in deep underground engineering. In order to simulate the progressive failure process of the hard brittle surrounding rockmass, a continuous discontinuous deformation analysis method that couples the finite element and discrete element is adopted. Taking the URL test tunnel in Canada as an engineering case, the constitutive model of the contact considering the effects of cohesion weakening and friction strengthening is applied, and the 2D approximation to 3D excavation by applying elastic modulus reduction technology is adopted to simulate the range and depth of crack growth of the surrounding rockmass. Then, the comparison between simulated results and on‐site monitoring results is performed, which shows good consistency. At the same time, the key factors in the numerical simulation of progressive failure in hard brittle rockmass are identified, including the number of elements, excavation effects, and constitutive models. The results show that the constitutive model determines the basic form of crack propagation, but in order to accurately simulate the progressive propagation of cracks, the number of elements must be sufficient enough and the effects of 3D excavation must be considered. The analysis accurately simulates the progressive failure characteristics of hard brittle surrounding rockmass under high stress, achieving the purpose of reasonably grasping the degree of damage to the surrounding rockmass, and provides technical reference and support on how to accurately simulate the failure of hard brittle surrounding rockmass using the finite discrete element method.