A high-performance bifunctional Co–P foam catalyst was successfully synthesized by facile one-step electrodeposition at a high cathodic current density. The synthetic approach includes fast generation of hydrogen bubbles as well as fast deposition of Co–P, which played a key role in forming a porous Co–P foam structure. The Co–P foam exhibits remarkable electrocatalytic activity and stability in both acidic and alkaline solution. Its HER activity was recorded with an overpotential of 50 mV in 0.5 M H2SO4 and 131 mV in 1 M KOH at 10 mA cm−2, which is comparable to that of commercial Pt/C (η@10 mA cm−2 0.5 M H2SO4 : 33 mV, η10 mA, 1 M KOH: 80 mV). The Co–P foam (η@10 mA cm−2: 300 mV) exhibits better OER activities than Ir/C (η@10 mA cm−2: 345 mV) and RuO2 (η@10 mA cm−2: 359 mV) in 1 M KOH solution. The excellent performance of the Co–P foam as an HER and OER catalyst can be attributed to the charge separation between Co and P in Co–P foam as well as the porous foam structure providing a large electrochemically active surface area (ECSA). The ECSA of the Co–P foam was calculated to be 118 cm2, which was 2.4 times higher than that of a Co–P film (49 cm2).
The development of high-efficiency catalysts for hydrogen evolution reaction (HER) and oxygen evolution reaction (OER) is essential to lower the energy losses during water electrolysis. Herein, a highly porous Ni–P (HP Ni–P) electrode, prepared by an ultrafast electrodeposition within only ten seconds, is presented with superior electrocatalytic activity towards both HER and OER in alkaline media: overpotentials of 96 and 323 mV are required to reach a current density level of 100 mA cm−2 for HER and OER, respectively, with corresponding Tafel slopes of 32.9 and 44.0 mV dec−1. Experimental analyses and theoretical calculations show that charge transfer occurs from Ni to P and the HER kinetics is accelerated by the increased hydrogen coverage, enhanced water dissociation ability, and optimized hydrogen adsorption energy on the HP Ni–P. Under OER conditions, surface P is oxidized into PO43−, promoting oxidation of Ni to OER-active NiOOH and exposing abundant OER-active sites on the HP Ni–P surface. An alkaline electrolysis cell was constructed with HP Ni–P as the cathode and anode (Ni–P‖Ni–P) and outperformed the Pt/C‖IrO2 cell at cell voltages exceeding 1.68 V. This work provides a practically applicable method to prepare HER and OER electrodes for use in industrial water electrolyzers, with insight into the activities of the catalysts.