In response to present‐day ice mass loss on and near the Greenland Ice Sheet, steady crustal uplifts have been observed from the network of Global Positioning System (GPS) stations mounted on bedrock. In addition to the secular uplift trends, the GPS time series also show prominent annual variability. Here we examine the annual changes of the vertical displacements measured at two GPS stations (SRMP and UPVK) near Upernavik Isstrøm in western Greenland. We model elastic loading displacements due to various surface mass loading including three nonice components: atmospheric pressure, ocean bottom pressure, continental water storage, and one ice component, i.e., surface mass balance (SMB). We find that the contribution from atmospheric pressure changes can explain 46% and 78% of the annual amplitude observed in the GPS verticals at SRMP and UPVK, respectively. We also show that removing the predicted loading displacements due to SMB adversely increases the annual variance of the GPS residuals. However, using the GPS data alone, we cannot identify the exact cause(s) of this discrepancy because the annual loading displacements are sensitive to the SMB changes from over 85% of the ice sheet area. Alternatively, by differencing vertical displacements between the two stations, we find a good agreement between the modeled differential SMB loading displacements and the GPS residuals after removing nonice components. Our study highlights the necessity of correcting for nonice loading contributions in the GPS measurements of crustal deformation to infer ice mass changes in Greenland at annual periods.
The transport properties in rock fractures depend on the aperture size and its distribution. The ability to infer fracture aperture distribution from flow data would provide significant amount of information for reservoir characterization and monitoring. In this study, fluid flow and transport properties are carefully examined using numerical simulations on rough rock fractures, whose the aperture distributions are controlled by surface height variance, its autocorrelation length, and the external compression state. It was found that 1) combinations of different autocorrelation lengths and surface variances yielded fractures of distinct effective permeability; 2) unique definition of the rough fracture cannot be resolved using flow and transport properties at a static compressional state; and 3) transport properties under different compressions could be used to better constrain the aperture distribution. Presentation Date: Tuesday, September 26, 2017 Start Time: 9:20 AM Location: Exhibit Hall C/D Presentation Type: POSTER
The roughness of fracture surfaces controls both the flow and elastic properties. While the aperture opening and its height controls the flow and transport properties, the contacted area and the stress-free surface determine the elastic properties. An implicit, and potentially complicated relation exists connecting these two properties. In this paper, we demonstrate that, with a fracture in a granite core, the static compressibility of the fracture can be estimated from the steady state flow measurements. We establish an empirical relation between the compression displacement and the effective pressure, based on numerical simulations of fluid-flow through the digitized fracture surface. The resulting empirical relation shows reasonable agreement compared with those presented in earlier literatures. Presentation Date: Tuesday, October 16, 2018 Start Time: 8:30:00 AM Location: 202A (Anaheim Convention Center) Presentation Type: Oral
14 June 2016 in The Journal of Clinical Pharmacology