To meet modern complex control systems communication demands, the paper presents a multi-channel UART controller based on FIFO (first in first out) technique and FPGA (field programmable gate array). The paper presents design method of asynchronous FIFO and structure of the controller. This controller is designed with FIFO circuit block and UART (universal asynchronous receiver transmitter) circuit block within FPGA to implement communication in modern complex control systems quickly and effectively. Form the communication sequence diagrams, it is easily to know that this controller can be used to implement communication when master equipment and slaver equipment are set at different Baud Rate. It also can be used to reduce synchronization error between sub-systems in a system with several sub-systems. The controller is reconfigurable and scalable.
Based on the current research results of anthropomorphic-arm bionics and parallel manipulators, a motion control approach for a 7-DOF cable-driven manipulator is proposed. This paper introduces mechanical structure design of this anthropomorphic-arm first. For the inverse kinematics of the 7-DOF manipulator, a hybrid algorithm, based on gradient projection method and Paden-Kahan sub problems, is proposed to make the trajectory tracing of the manipulator in task space with high accuracy; a joint rate redistribution approach is also employed to optimize kinematic performance criterion and improve the fault-tolerance of the manipulator. The coupling cable lengths among the different joint modules, i.e., shoulder, elbow, and wrist joints, are analyzed in detail. Finally, to demonstrate the proposed algorithm, by utilizing ADAMS software, a straight-line trajectory motion simulation for the 7-DOF cable-driven manipulator is realized
Based on Bluetooth technology, this paper introduces a method of wireless communication between a manipulator and PC. A RS232 interface is connected between PC and Bluetooth module, and the manipulator controller and Bluetooth module are connected by UART. PC detects, communicates and initializes the Bluetooth module using software designed for it, and manipulator communicates with the Bluetooth module using Host Controller Interface program. Via this approach, the paper realizes the communication between a manipulator and PC. The paper first introduces the Bluetooth technology, then the methods of hardware and software designs for the system are proposed. Finally, through an experiment, the paper verifies the wireless communication between PC and a manipulator via two Bluetooth modules is feasible.
This paper introduces the design process of a virtual oscillograph based on LabVIEW. Mainly analyzes the amplitude value and time base adjusting methods during the real-time display. At the same time, it simply introduces the basic thought when measuring the period and frequency of the waveform-gate voltage method and its application. At the end of this paper, combining the parameter measurement and waveform display of the virtual oscillograph with the modern motor close-loop lock-phase speed control, it analyzes the parameter measurement's effect in PID control.