School of Environmental Science and Engineering, Shanghai Jiao Tong University, 800 Dong Chuan Road, Shanghai 200240, PR China; Shanghai Engineering Research Center of Solid Waste Treatment and Resource Recovery, Shanghai 200240, PR China
Auto-generated profile, based on publicly available information
Mingming Guo
School of Environmental Science and Engineering, Shanghai Jiao Tong University, 800 Dong Chuan Road, Shanghai 200240, PR China; Shanghai Engineering Research Center of Solid Waste Treatment and Resource Recovery, Shanghai 200240, PR China
Series of α, β, γ, δ type MnO2 supported on LaMnO3 perovskite was developed by a one-pot synthesis route. Compared with α-MnO2, β-MnO2, γ-MnO2, δ-MnO2 and LaMnO3 oxides, all MnO2/LaMnO3 showed promotional catalytic performance for toluene degradation. Among them, α-MnO2/LaMnO3 holds the best active and mineralization efficiency. By the analysis of N2 adsorption-desorption, XPS and H2-TPR, it can be inferred that the improved activity should be ascribed to the higher proportion of lattice oxygen, better low-temperature reducibility and larger specific surface area. Besides, the byproducts from the low-temperature reaction of toluene oxidation were detected by a TD/GC-MS, confirming the presence of the intermediates. Combined with the in-situ DRIFTS, the catalytic degradation path of toluene oxidation has also been discussed in depth.
In this work, solar drying technology was applied for the deep dewatering of coal slime to save thermal energy and reduce the dust produced during the hot drying process of coal slime. Solar drying technology is used to dry coal slime to realize its resource utilization. The influence of solar radiation intensity and slime thickness is investigated on the drying process. The greater the solar radiation intensity (SRI) is, the faster the drying indoor air and coal slime are heated, and the faster the drying efficiency is. As the slime becomes thinner, the internal water diffusion resistance becomes smaller and the drying efficiency correspondingly becomes faster. In addition, to facilitate the application of coal slime drying in the actual project, the Page model is fitted and found to have a good fit for solar drying coal slime. Meanwhile, the optimal drying conditions are determined by analyzing the energy utilization under different conditions. It is found that the target moisture content of 10% is optimal for coal slime drying with the highest energy utilization. The laying thickness (L) of 1 cm has the highest solar thermal efficiency of 54.1%. More importantly, economic calculation and analysis are conducted in detail on solar drying. It is found that the cost of solar drying (¥38.59/ton) is lower than that of hot air drying (¥ 65.09/ton). Therefore, solar drying is a promising method for the drying of coal slime.