5 December 2018 in Nano Letters
16 November 2018 in Nano Letters
1 March 2016 in Royal Society Open Science
A single photon avalanche diode (SPAD) with an InGaAs absorption region, and an InAlAs avalanche region was designed and demonstrated to detect 1550 nm wavelength photons. The characterization included leakage current, dark count rate and single photon detection efficiency as functions of temperature from 210 to 294 K. The SPAD exhibited good temperature stability, with breakdown voltage dependence of approximately 45 mV K −1 . Operating at 210 K and in a gated mode, the SPAD achieved a photon detection probability of 26% at 1550 nm with a dark count rate of 1 × 10 8 Hz. The time response of the SPAD showed decreasing timing jitter (full width at half maximum) with increasing overbias voltage, with 70 ps being the smallest timing jitter measured.
11 September 2014 in Optics Express
An InGaAs/InAlAs Single Photon Avalanche Diode was fabricated and characterized. Leakage current, dark count and photon count measurements were carried out on the devices from 260 to 290 K. Due to better temperature stability of avalanche breakdown in InAlAs, the device breakdown voltage varied by < 0.2 V over the 30 K temperature range studied, which corresponds to a temperature coefficient of breakdown voltage less than 7 mV/K. The single photon detection efficiency achieved in gated mode was 21 and 10% at 260 and 290 K, respectively. However the dark count rates were high due to excessive band-to-band tunneling current in the InAlAs avalanche region.
25 March 2016 in Journal of Applied Physics
Electrical characterization of two GaAs p+-i-n+ mesa X-ray photodiodes over the temperature range 0 °C to 120 °C together with characterization of one of the diodes as an X-ray detector over the temperature range 0 °C to 60 °C is reported as part of the development of photon counting X-ray spectroscopic systems for harsh environments. The randomly selected diodes were fully etched and unpassivated. The diodes were 200 μm in diameter and had 7 μm thick i layers. The leakage current density was found to increase from (3 ± 1) nA/cm−2 at 0 °C to (24.36 ± 0.05) μA/cm−2 at 120 °C for D1 and from a current density smaller than the uncertainty (0.2 ± 1.2) nA/cm−2 at 0 °C to (9.39 ± 0.02) μA/cm−2 at 120 °C for D2 at the maximum investigated reverse bias (15 V). The best energy resolution (FWHM at 5.9 keV) was achieved at 5 V reverse bias, at each temperature; 730 eV at 0 °C, 750 eV at 20 °C, 770 eV at 40 °C, and 840 eV at 60 °C. It was found that the parallel white noise was the main source of the photopeak broadening only when the detector operated at 60 °C, at 5 V, 10 V, and 15 V reverse bias and at long shaping times (>5 μs), whereas the sum of the dielectric noise and charge trapping noise was the dominant source of noise for all the other spectra.
27 March 2017 in Nano Letters