The temperature-composition phase diagram of barium calcium titanate zirconate (x(Ba0.7Ca0.3TiO3)-(1 − x)(BaZr0.2Ti0.8O3); BCTZ) has been reinvestigated using high-resolution synchrotron x-ray powder diffraction. Contrary to previous reports of an unusual rhombohedral-tetragonal phase transition in this system, we have observed an intermediate orthorhombic phase, isostructural to that present in the parent phase, BaTiO3, and we identify the previously assigned T-R transition as a T-O transition. We also observe the O-R transition coalescing with the previously observed triple point, forming a phase convergence region. The implication of the orthorhombic phase in reconciling the exceptional piezoelectric properties with the surrounding phase diagram is discussed.
In this work, we studied the effect of heterovalent Ca, Sr, Pb, and Ba substitution on the crystal structure, dielectric, local ferroelectric, and magnetic properties of the BiFeO3 multiferroic perovskite. Ceramic solid solutions with the general formula Bi0.7A0.3FeO3 (A is a doping element) were prepared and characterized by x-ray diffraction, dielectric, piezoresponse force microscopy (PFM), and magnetic measurements. It is shown that the crystal structure of the compounds is described within the space group R3c, permitting the spontaneous polarization, whose existence was confirmed by the PFM data. Magnetic properties of the solid solutions are determined by the ionic radius of the substituting element. Experimental results suggest that the increase in the radius of the A-site ion leads to the effective suppression of the spiral spin structure of BiFeO3, resulting in the appearance of net magnetization.
30 January 2004 in Journal of Physics: Condensed Matter
The interface formation of Nb-doped single crystals and thin films with Pt has been studied by using photoelectron spectroscopy with in situ sample preparation. For the single crystal sample, a Schottky barrier height for electrons of 0.5–0.6 eV is determined after deposition of Pt in vacuum environment. After annealing in 0.05 Pa oxygen pressure, a strong increase in the barrier height to is observed. X-ray induced photovoltages of up to 0.7 eV are observed in this case and have to be taken into account for a proper determination of the barrier height. A subsequent annealing in vacuum reduces the barrier again. Hence, the barrier height can be reversibly switched between an oxidized state with a large barrier height and a reduced state with a low barrier height. Quantitative analysis of the barrier heights indicates that the changes are related to the changes of interfacial defect concentration. Due to the occurrence of a related signal, the defects are identified as oxygen vacancies. The same effects are observed at interfaces between Pt and thin films with a smaller absolute value of the barrier height in the oxidized state of . Deposition of onto a metallic Pt substrate also results in a barrier height of 1.0 eV.
Spark plasma sintering (SPS) is an efficient tool to obtain highly densified ferroelectric-dielectric ceramic composites with clean interfaces and tunable properties. Dielectric MgO and ferroelectric (BST) were combined in two-dimensional multilayer and three-dimensional random powders design. Their unmodified BST Curie temperature proves the suppression of interdiffusion while dielectric losses are below 0.5% and the tunability is 40% at room temperature. The composites and pure BST with similar densities were obtained, owing reliable comparison of their dielectric properties. Such SPS ceramics can be used as experimental input for simulation and are potential candidates for high frequency applications.