6 February 2020 in Physical Review Letters
Magnets with chiral crystal structures and helical spin structures have recently attracted much attention as potential spin-electronics materials, but their relatively low magnetic-ordering temperatures are a disadvantage. While cobalt has long been recognized as an element that promotes high-temperature magnetic ordering, most Co-rich alloys are achiral and exhibit collinear rather than helimagnetic order. Crystallographically, the B20-ordered compound CoSi is an exception due to its chiral structure, but it does not exhibit any kind of magnetic order. Here, we use nonequilibrium processing to produce B20-ordered with a maximum Co solubility of . Above a critical excess-Co content (), the alloys are magnetically ordered, and for , a critical temperature is obtained, the highest among all B20-type magnets. The crystal structure of the alloy supports spin spirals caused by Dzyaloshinskii-Moriya interactions, and from magnetic measurements we estimate that the spirals have a periodicity of about 17 nm. Our density-functional calculations explain the combination of high magnetic-ordering temperature and short periodicity in terms of a quantum phase transition where excess-cobalt spins are coupled through the host matrix.
21 October 2019 in Applied Physics Letters
A nonequilibrium rapid-quenching method has been used to fabricate NiMnIn and NiMnGa alloys that are chemically and morphologically similar but crystallographically and physically very different. NiMnGa crystallizes in a Ni2In-type hexagonal structure, whereas NiMnIn is a cubic Heusler alloy. Both alloys yield a topological Hall effect contribution corresponding to bubble-type skyrmion spin structures, but it occurs in much lower magnetic fields in NiMnIn as compared to NiMnGa. The effect is unrelated to net Dzyaloshinskii-Moriya interactions, which are absent in both alloys due to their inversion-symmetric crystal structures. Based on magnetic-force microscopy, we explain the difference between the two alloys by magnetocrystalline anisotropy and uniaxial and cubic anisotropies yielding full-fledged and reduced topological Hall effects, respectively. Since NiMnIn involves small magnetic fields (0.02–0.3 kOe) at and above room temperature, it is of potential interest in spin electronics.
1 December 2019 in APL Materials
Permanent-magnet materials are one cornerstone of today’s technology, abundant in disk drives, motors, medical equipment, wind generators, and cars. A continuing challenge has been to reconcile high permanent-magnet performance with low raw-material costs. This work reports a Mn-Bi-Sn alloy exclusively made from inexpensive elements, exhibiting high values of Curie-temperature, magnetization, anisotropy, coercivity, and energy product. The samples are produced by field annealing of rapidly quenched Sn-containing MnBi alloys, where the improvement of the magnetic properties is caused by the substitutional occupancy of the 2c sites in the hexagonal NiAs structure by Sn. The substitution modifies the electronic structure of the compound and enhances the magnetocrystalline anisotropy, thereby improving the coercivity of the compound. The energy product reaches 114 kJ/m3 (14.3 MGOe) at room temperature and 86 kJ/m3 (10.8 MGOe) at 200 °C; this value is similar to that of the Dy-free Nd2Fe14B and exceeds that of other rare-earth-free permanent-magnet bulk alloys, as encountered in automotive applications.
11 April 2019 in IEEE Transactions on Magnetics
The relationship between atomic-scale and micromagnetic Dzyaloshinski-Moriya (DM) interactions has been investigated. By analyzing the Lifshitz invariants for different point groups, we have found that there is no unique link between the absence of inversion symmetry and DM interactions. The absence of inversion symmetry is a necessary condition for a net DM interaction in crystals, but several noncentrosymmetric point groups have zero DM interactions. In many cases, the key consideration is whether the crystals are polar and/or chiral. For example, MnSi-type spin spirals, which violate helical spin symmetry, are caused by the insertion of chiral atomic-scale building blocks into an achiral cubic lattice, and the scalar interaction parameter D used to describe the spirals is only loosely related to the DM vector D. It contains, in fact, magnetostatic and magnetocrystalline contributions of unknown magnitude. Finally, we discuss some aspects of the micromagnetism of the skyrmionics of nanoparticles and granular nanostructures.
29 July 2022 in Physical Review Materials
In the course of searching for promising topological materials for applications in future topological electronics, we evaluated spin-orbit torques (SOTs) in high-quality sputtered δ-TaN/ devices through spin-torque ferromagnetic resonance (ST-FMR) and spin pumping measurements. From the ST-FMR characterization we observed a significant linewidth modulation in the magnetic layer attributed to the charge-to-spin conversion generated from the δ-TaN layer. Remarkably, the spin-torque efficiency determined from ST-FMR and spin pumping measurements is as large as 0.034 and 0.031, respectively. These values are over two times larger than for α-Ta, but almost five times lower than for β-Ta, which can be attributed to the low room temperature electrical resistivity in δ-TaN. A large spin diffusion length of at least is estimated, which is comparable to the spin diffusion length in pure Ta. Comprehensive experimental analysis, together with density functional theory calculations, indicates that the origin of the pronounced SOT effect in δ-TaN can be mostly related to a significant contribution from the Berry curvature associated with the presence of a topically nontrivial electronic band structure in the vicinity of the Fermi level (). Through additional detailed theoretical analysis, we also found that an isostructural allotrope of the superconducting δ-TaN phase, the simple hexagonal structure θ-TaN, has larger Berry curvature, and that, together with expected reasonable charge conductivity, it can also be a promising candidate for exploring a generation of spin-orbit torque magnetic random access memory as cheap, temperature stable, and highly efficient spin current source.
1 November 2021 in Journal of Magnetism and Magnetic Materials