BH4-substituted argyrodite solid electrolytes are mechanically softer and achieve near-theoretical density at lower pressures and room temperature compared to Cl- or Br-substituted counterparts, which is consistent with nanoindentation test results.
30 December 2025 in Journal of Materials Research and Technology
In this study, the perforation behaviors of commercial Armox 500T and Armox 600T were investigated under various projectile velocities. The failure mechanisms were analyzed from the macroscopic to the nanoscale using X-ray computed tomography (X-ray CT), electron backscatter diffraction (EBSD), and transmission electron microscopy (TEM). Under complete perforation conditions, Armox 600T exhibited greater initial resistance owing to its higher hardness but suffered severe rear-side damage (plugging and spalling). By contrast, Armox 500T exhibited extensive ductile hole expansion, maintaining a residual volume of approximately 99%. Microstructural characterization demonstrated that adiabatic shear bands (ASBs) were prominent near the perforation surfaces and along the radial cracks in both steels. The occurrence of dynamic recrystallization and even localized melting inside the ASBs induced microcracks along the ASB/matrix interfaces and prior austenite grain (PAG) boundaries, eventually coalescing into the observed macroscopic radial cracks. These findings suggest that the design of high-performance armor steels should be based on an optimized balance between hardness and dynamic damage tolerance.