We systematically used two approaches to analyze broadband seismic signals for monitoring active volcanoes: one is waveform inversion of very‐long‐period (VLP) signals assuming possible source mechanisms; the other is a source location method of long‐period (LP) events and tremor using their amplitudes. The deterministic approach of the waveform inversion is useful to constrain the source mechanism and location but is basically only applicable to VLP signals with periods longer than a few seconds. The source location method assumes isotropic radiation of S waves and uses seismic amplitudes corrected for site amplifications. This simple approach provides reasonable source locations for various seismic signals such as a VLP event accompanying LP signals, an explosion event, and tremor associated with lahars and pyroclastic flows observed at five or fewer stations. Our results indicate that a frequency band of about 5–12 Hz and a Q factor of about 60 are appropriate for the determination of the source locations. In this frequency band the assumption of isotropic radiation may become valid because of the path effect caused by the scattering of seismic waves. The source location method may be categorized as a stochastic approach based on the nature of scattering waves. Systematic use of these two approaches provides a way to better utilize broadband seismic signals observed at a limited number of stations for improved monitoring of active volcanoes.
1 September 2008 in Journal of Volcanology and Geothermal Research
Understanding the plumbing system structure below volcanoes and the storage conditions (temperature, pressure, volatile content and oxygen fugacity) of erupted magmas is of paramount importance for eruption forecasting and understanding of the factors controlling eruptive dynamics. Phase equilibria experiments have been performed on a Tungurahua andesite (Ecuador) to shed light on the magmatic conditions that led to the July–August 2006 eruptions and the parameters that controlled the eruptive dynamics. Crystallization experiments were performed on a representative August 2006 mafic andesite product between 950 and 1025°C, at 100, 200 and 400 MPa and NNO + 1 and NNO + 2 (where NNO is nickel–nickel oxide buffer), and water mole fractions in the fluid (XH2O) from 0·3 to 1 (water-saturation). Comparison of the natural phenocryst assemblage, proportions and phenocryst compositions with our experimental data indicates that the natural andesite experienced two levels of ponding prior to the eruption. During the first step, the magma was stored at 400 MPa (15–16 km), 1000°C, and contained c. 6 wt % dissolved H2O. In the second step, the magma rose to a confining pressure of 200 MPa (8–10 km), where subsequent cooling (to 975°C) and water-degassing of the magma led to the crystallization of reversely zoned rims on pre-existing phenocrysts. The combination of these processes induced oxidation of the system and overpressure of the reservoir, triggering the July 2006 eruption. The injection of a new, hot, volatile-rich andesitic magma from 15–16 km into the 200 MPa reservoir shortly before the eruption was responsible for the August 2006 explosive event. Our results highlight the complexity of the Tungurahua plumbing system in which different magmatic reservoirs can coexist and interact in time and are the main controlling factors of the eruptive dynamics.