This paper demonstrates high-frequency dynamic strain measurements using Fiber Bragg Grating (FBG) sensors embedded in metal parts. Using an ultrasonic additive manufacturing (UAM) process, FBGs inscribed in polyimide coated optical fibers were embedded in aluminum parts. An electromagnetic shaker was used to exert dynamic events on the embedded FBG sensors with frequencies from 1–10 kHz. The high-speed interrogation of FBG sensors was accomplished using a tunable vertical-cavity surface-emitting laser (VCSEL) and a high-speed interrogation system sampling at 120 kHz. The strain response measured by the FBG sensors was compared with real-time measurements using a laser velocimeter. Finite Element Analysis was performed to simulate responses to both static strain and high-frequency dynamic strain. Results show that strains as small as 2.5 μ can be resolved at frequencies up to 10 kHz.
Qualifying large-scale metal additive manufacturing (M-AM) technologies such as wire arc additive manufacturing (WAAM) can be challenging. This is especially significant in precipitation hardened martensitic stainless steels like SS 17-4PH, where thermal histories induce location-specific microstructural variability and property anisotropy. The Department of Defense (DOD) and the United States Army Combat Capabilities Development Command Ground Vehicle Systems Center (GVSC) Ground Vehicle Materials Engineering (GVME) aim to build robust and qualified large-scale M-AM workflows that could reduce the time and cost through quick and informed evaluation, testing, and development of feedstock, processes, and parts. The report presents the findings from the collaborative efforts between Oak Ridge National Laboratory (ORNL) and the U.S. Army GVSC GVME. The aim of this project was to develop a geometric feature-based qualification framework for WAAM of SS 17-4PH components. This report outlines selection methodology of representative build geometries, optimization of WAAM process parameters, in-situ monitoring, microstructure-property evaluation, thermal simulations, as well as data visualization techniques incorporated in this project. The results from this project demonstrate a clear understanding of thermal history dependent phase evolution and consequent location-specific property variations in WAAM of SS 17-4PH. These results in conjunction with the data-driven methodologies used in this project are expected to reduce qualification timelines, improve predictability, and accelerate the development of reliable feature-based qualification strategies for part production via large-scale M-AM technologies.
As an additive manufacturing (AM) process, wire-arc directed energy deposition (DED) has drawn increasing attention due to its ability to print large metal parts. However, the heat accumulation during the deposition may result in significant residual stress and distortion in the as-built part. Although post heat treatment can relieve the residual stress, most of the distortion remains, thus making post-processing such as machining and cutting more difficult. As a numerical modeling approach, the modified inherent strain (MIS) method has been proven effective for predicting residual stress and distortion of small parts manufactured by the laser powder bed fusion (L-PBF) and powder DED process. In this work, the MIS method is extended to include the effect of heat accumulation so that it can be applied to large parts built by wire-arc DED. In the extended MIS method, inherent strains are not constant but temperature dependent. Instead of loading inherent strains layer-by-layer, the extended method divides each layer into several segments according to the deposition path and sequentially loads inherent strains based on the interpass temperature of the build. A flash heating simulation involving transient thermal analysis is added to obtain the interpass temperature. The experimental measurement shows that the temperature-dependent MIS method is able to predict both residual stress and deformation of as-built parts with good accuracy.