Jianbin Li

Jianbin Li

Auto-generated profile, based on publicly available information

Jianbin Li

State Key Laboratory of Oil and Gas Reservoir Geology and Exploitation, Southwest Petroleum University

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
4 October 2021 in RSC Advances
Verified
Journal Article
Open access
PDF file
ZLZhifeng Luo
Zhifeng Luo
JLJianbin Li
Jianbin Li
LZLiqiang Zhao
Liqiang Zhao
NZNanlin Zhang
Nanlin Zhang
XCXiang Chen
Xiang Chen
CLChong Liang
Chong Liang
A self-suspending ultra-low density proppant (UDP) was developed based on the polymerization of the unsaturated carbon double bond. Its performance was characterized by FT-IR and SEM, and the sphericity and roundness, diameter distribution, density, mechanical properties, the conductivity of the propped fracture, and mass loss of different fluids were measured. The test results indicated that the UDP no longer contained the unsaturated carbon double bond and the polymerization took place in the raw material. The fracture surface of UDP is compact and it is not easy to produce debris after compression failure. The sphericity and roundness of UDP were above 0.9, and the high sphericity and roundness provided high conductivity. The stirring speed has a great influence on the diameter of UDP, and the UDP with different sizes could be used to prop the hydraulic fracture to different widths. The average apparent density of UDP is as low as 1.044 g cm−3, and it can be suspended in the fracturing fluid for a long time. The strain in the UDP is higher than that in the ceramsite and quartz sand, but its crushing ratio is far below theirs; therefore, the conductivity of the fracture propped by UDP was higher than that of quartz sand and ceramsite. The solubility of UDP in kerosene, reservoir water, and hydrochloric acid is below 1%, indicating that the UDP is also suitable for acid fracturing with proppant. All the experimental results proved that the self-suspending ultra-low density proppant has great potential use in hydraulic fracturing and acid fracturing.

21 May 2024 in SPE Journal
Verified
Journal Article
Closed access
PDF file
JLJianbin Li
Jianbin Li
ZLZhifeng Luo
Zhifeng Luo
NZNanlin Zhang
Nanlin Zhang
XZXiuquan Zeng
Xiuquan Zeng
YJYucheng Jia
Yucheng Jia
Summary: Shale reservoirs have longitudinally developed multilayered weak surfaces. The strong geological discontinuity and the stress heterogeneity caused by it lead to the complicated morphology of hydraulic fracture propagation, and the longitudinal propagation mechanism of the hydraulic fracture is still unclear. The extended finite element 3D numerical model of the single-cluster fracture and multicluster fracture extension has been established. The effects of vertical stress difference, bonding strength of bedding plane, fracturing fluid displacement, fracturing fluid viscosity, and cluster spacing on fracture propagation morphology are analyzed by numerical examples. The results show that as the vertical stress difference and the bonding strength of the bedding plane increase, the bedding plane becomes more difficult to activate, and the fractures are more likely to realize the longitudinal penetration. As the cluster spacing decreases, the interfracture interference becomes stronger, and the hydraulic fractures are more likely to activate the bedding plane and form the orthogonal network fracture. At a high injection rate, the fracture passes easily through the layer and activates the bedding plane. Low-viscosity fracturing fluid is conducive to the activation of the bedding plane, and high-viscosity fracturing fluid can better achieve fracture penetration. Based on the research results, the fracturing parameters of Well X-1 are optimized, and the fracture monitoring results are in good agreement with the design objectives. This study reveals the longitudinal penetration mechanism of multilayered shale hydraulic fractures and provides a reference for the optimization of hydraulic fracturing parameters of multilayered shale.

2 October 2023 in Journal of Dispersion Science and Technology
Verified
Journal Article
Closed access
ZLZhifeng Luo
Zhifeng Luo
JLJianbin Li
Jianbin Li
NZNanlin Zhang
Nanlin Zhang
HFHaoran Fu
Haoran Fu
JHJiahong Huang
Jiahong Huang
HSHao Sun
Hao Sun

1 November 2024 in Physics of Fluids
Verified
Journal Article
Closed access
PDF file
ZLZhifeng Luo
Zhifeng Luo
JLJianbin Li
Jianbin Li
CLChang Liu
Chang Liu
LCLong Cheng
Long Cheng
NZNanlin Zhang
Nanlin Zhang
JZJianping Zhou
Jianping Zhou
Plugging and diverting stimulation technology using temporary plugging balls (PDSTB) in horizontal wells is one of the effective measures to enhance production in heterogeneous carbonate reservoirs. However, the migration and plugging mechanism of temporary plugging balls in horizontal wells remain unclear, leading to suboptimal field application. Based on the Lagrangian method, the migration and plugging models of temporary plugging balls were established. The study investigated the migration and plugging mechanism of temporary plugging balls. It analyzed the effects of parameters such as displacement on the plugging efficiency. The results show that the flow field in the perforation section is significantly affected by the displacement. Temporary plugging balls show three states of plugging: one ball plugging one shot-hole, multiple balls plugging one shot-hole, and balls remaining in the wellbore. The plugging efficiency initially increases, and then, decreases with the increase in displacement and the ball diameter. The plugging efficiency initially increases, and then, stabilizes with the increase in the viscosity of the carrying fluid and the usage ratio of balls. Plugging efficiency decreases with increasing density of balls. The greater the pressure difference at the outlet of the perforation section, the higher the plugging efficiency in the advantageous inlet section. Based on these results, the field construction of Well M was guided. The gas production was 142.66 × 104 m3/d after stimulation, and the production increase was significant. This study provides a theoretical basis for optimizing and designing the parameters of PDSTB in carbonate long horizontal wells.

21 March 2024
Verified
Book Chapter
Closed access
PDF file
ZLZhi-Feng Luo
Zhi-Feng Luo
JLJian-Bin Li
Jian-Bin Li
NZNan-Lin Zhang
Nan-Lin Zhang
XZXiu-Quan Zeng
Xiu-Quan Zeng
YJYu-Cheng Jia
Yu-Cheng Jia

9 December 2025 in Petroleum Science and Technology
Verified
Journal Article
Closed access
ZXZe-Hao Xu
Ze-Hao Xu
XCXu-Sheng Cao
Xu-Sheng Cao
ZLZhifeng Luo
Zhifeng Luo
LCLong Cheng
Long Cheng
JLJian-Bin Li
Jian-Bin Li