13 January 2025 in IEEE Journal of Oceanic Engineering
One of the primary goals in the development of underwater wireless optical communication (UWOC) is to extend the link length. Meanwhile, the key to increasing the link length of UWOC is to decrease the attenuation of the optical signals underwater. This work demonstrates that a decreased underwater attenuation coefficient and improved communication performance can be achieved by using a pulsed laser. The pulsed blue laser used in the experiment is a self-Q-switched semiconductor disk laser, whose Q-switching is initiated by the nonlinear Kerr effect of the multiple quantum wells in the active region of the gain chip. The width of the laser pulse is about a few nanoseconds and the repetition rate of the output pulse train is in the order of tens of megahertz. According to the measurements of the attenuation coefficients at various concentrations of Maalox solution, the pulsed laser has a significantly smaller attenuation coefficient than the continuous-wave laser, and this drop in attenuation coefficient is particularly noticeable in turbid water with a higher concentration of Maalox solution. The attenuation coefficient of the pulsed laser was only 62% of the continuous-wave laser at a Maalox concentration of 2905 mg·m −3 . Subsequent tests reveal that the lower attenuation coefficient of the pulsed laser is mainly resulted from the reduced scattering it encounters underwater, rather than the ignorable decrease in the attenuation coefficient raised from the water's absorption of the laser. A UWOC system based on the above pulsed laser has also been built and much better communication performance compared to the continuous-waves laser has been obtained. The bit error rate of the UWOC based on the pulsed laser is 1–2 orders of magnitude lower than that of the UWOC with a continuous-wave laser when the data rate is 10 Mb/s and the link length is 18 m.
29 August 2024 in Optics Express
Reducing the repetition rate is one of the effective ways to increase the peak-power of the mode-locked pulses. However, for a vertical-external-cavity surface-emitting laser (VECSEL), the carrier lifetime in the nanosecond regime limits the further reduction of the pulse repetition rate, or in other words, limits the average output power of the mode-locked laser at low repetition rates, and ultimately restricts the peak-power of the pulses. This work uses a specially designed saturable Bragg reflector to start the mode-locking, and both low repetition rate and high average power are achieved simultaneously in a passively mode-locked VECSEL. When the repetition rate of the pulses is 78 MHz, a peak power of 12.9 kW, twice the reported highest value, is achieved. The pulse repetition rate is further reduced to the lowest value of 67 MHz, and peak-powers of 2.33, 3.00 and 1.23 kW under the fundamental, second-harmonic, and fourth-harmonic mode-locking are demonstrated, respectively. In addition, a theoretical analysis of the influence of the saturation fluence of the saturable absorber on the evolution of the mode-locked pulses is also provided.
2 October 2024 in Journal of Lightwave Technology
We report a compact high-power narrow-linewidth 509 nm widely tunable single-frequency vertical-external-cavity surface-emitting laser (VECSEL) for the preparation of cesium Rydberg states. A record output power of 6.3 W near 509.140 nm is achieved, and the measured Gaussian linewidth (100 μs integration time) and Lorentzian linewidth of the fundamental wave within 1 ms sampling time are 19.3 kHz and 142.5 Hz, respectively. When the absorbed pump power is 28 W, the laser wavelength can be tuned from 502 nm to 516 nm, the output power is maintained between 29 mW and 5.4 W. This type of single-frequency laser provides a high-performance light source for research involving cesium Rydberg atoms, such as quantum computing, microwave electric field measurement, and terahertz imaging.
25 September 2024 in Optics Express
This paper presents a high power widely tunable frequency-doubled semiconductor disk laser emitting at 490 nm wavelength. The laser utilizes a specially designed gain chip with widened gain spectrum at the center wavelength of 980 nm, along with an anti-resonant microcavity, to extend the tuning range of the wavelength. A type-I phase-matched 5 mm length LBO crystal is used as the nonlinear crystal, and a fused quartz birefringent filter (BRF) is introduced to polarize the fundamental emission and narrow the linewidth of the laser. When the thickness of the used BRF is 1 mm, 50.7 nm tuning range of the 980 nm infrared laser is performed. A maximum output power of 5.36 W of the frequency-doubled 490 nm blue laser is achieved, and the optical-to-optical conversion efficiency from absorbed pump power to the blue light is about 15.3%. Meanwhile, a record tuning range of 21.5 nm of the blue laser is realized. The measured M2 factors of the blue laser are 1.00 in the x-direction and 1.04 in the y-direction, respectively.
29 January 2024 in Optics Express
Semiconductor disk lasers can produce high output power and good beam quality simultaneously. The high intracavity circulating power of about hundreds of watts, along with the flexibility of tailorable emitting wavelengths, make it an attractive light source for obtaining ultraviolet (UV) radiation from near-infrared lasers through nonlinear frequency conversion. This work reports a frequency tripled 327 nm semiconductor disk laser with record output power and wavelength tuning range by using a type-I phase-matched LiB3O5 (LBO) crystal and a type-I phase-matched β-BaB2O4 (BBO) crystal as the frequency-doubling and -tripling crystals respectively. Thanks to the obviously larger nonlinear coefficient of the type-I phase-matched BBO compared to the commonly used type-II phase-matched LBO, as well as the small spot size specifically designed at the crystal location, the maximum output power of UV lasers reaches 538 mW, corresponding to an optical-to-optical conversion efficiency from pump to UV laser of about 1.14%. A wavelength tuning range of about 8.6 nm and good power stability with a standard deviation of about 0.94 are also achieved.