The MMC-HVDC technology plays a great role on multilevel DC systems and large capacity transmission systems gradually. Therefore, the protection for MMC-HVDC system becomes particularly important, for the impact acreage of DC short faults is wider and damage is more serious. In this paper, the MMC-HVDC system electromagnetic transient characteristics of fault are analyzed and superconducting fault current limiter (SFCL) resistance model is established for a resistive SFCL (R-SFCL) during the short fault. The thermal-electrical process of R-SFCL limiting short current is calculated by iteration method. Then a R-SFCL based on noninductive bifilar pancake is designed for $\pm$ 160kV bipolar MMC-HVDC system. The correctness of the theoretical calculation method and design scheme is verified by the simulation in software PSCAD. The results show that the response time of the R-SFCL based on noninductive bifilar pancake is 0.1 ms and the short circuit current suppression rate is 50% ~ 35% in 3~8 ms after the DC short fault.
11 January 2018 in IEEE Transactions on Applied Superconductivity
The superconducting magnet wound by high temperature superconducting (HTS) wires attracts extensive interest in high magnetic field and at low temperature. However, different from the conventional low temperature superconducting (LTS) magnet, the persistent operation of the HTS magnet with persistent current switch (PCS) is not commercial at present because of the immature jointing technique between HTS wires. This paper presents a conceptual design of a Bitter-like superconducting magnet by stacking (RE= rare earth) BCO annular plates magnetized by flux pump, which can operate in persistent mode. The induced field characteristics and temporal response of the superconducting magnet were firstly analyzed by theoretical simulation using the Finite Element Method (FEM). The design method of REBCO annular plates and construction details of the Bitter-like superconducting magnet were then detailed herein. A model Bitter-like superconducting magnet was fabricated by stacking REBCO annular plates without joint resistance and its feasibility with persistent mode was experimentally validated at 77 K. The technology has potential application in NMR magnet and high field magnets.
23 August 2022 in Superconductor Science and Technology
The qualities of superconducting conductors are usually characterized by their critical current and n-value. In this paper, the critical current and the n-value of the second-generation (2G) high temperature superconducting (HTS) conductors considering the temperature-field dependence are predicted by a back propagation (BP) neural network as Jc(B, θ, T) and n(B,θ,T). A correlation exists between the critical current and the n-value, thus in our BP neural network, the tasks of estimating the critical current and the n-value can be carried out in one network. The outputs used to predict the critical current and the n-value share the same hidden layers of the network, and therefore the critical current and the n-value can be calculated simultaneously. The critical current and the n-value of HTS conductors vary for different manufacturers and even for the same manufacturer but different production batches. In our BP network, we use an encoder structure to encode different manufacturers and production batches to ensure that the network can be adapted to the HTS conductors so produced. The predictions on three different samples of HTS conductors are carried out and the results are compared with those obtained from linear interpolation at different temperature-field conditions. In addition to the high accuracy, when compared with the linear interpolation, the proposed network can suppress the fluctuations existing in the experimental data and ensure the prediction results to be more reasonable. The time required for the proposed network to obtain the prediction results of the critical current and the n-value is also discussed, which is within 5 s. Therefore, the proposed network has the potential to be applied to the optimization and analysis of the superconducting related equipment.
3 March 2020 in IEEE Transactions on Applied Superconductivity
In order to improve the thermal stability of high-temperature superconducting (HTS) strand, a quasi-isotropic superconducting strand (Q-IS) stacked by 2mm wide REBCO tapes and Cu tapes with geometrical symmetric configuration were developed, in this paper. A three dimensional (3D) numerical model considering the anisotropic thermal conductivity was built to study the thermal stability of the strand, including minimum quench energy (MQE) and quench propagation velocity (QPV). The temperature distribution in the cross section at different positions along the longitudinal direction of the strand during the quench was obtained as well. Then, a strand was prepared to investigate the thermal stability experimentally. Results show that the Q-IS stacked by REBCO tapes and copper tapes has higher MQE than Q-IS without copper tapes. The results can provide a fundamental analysis for further developing device of high-current electric power transmission with high thermal stability.
25 December 2017 in IEEE Transactions on Applied Superconductivity
This paper mainly presents an ac loss numerical study of quasi-isotropic strands fabricated by second generation wires in cryogenic temperatures of 4.2 and 77 K. In order to estimate the ac losses accurately, a scaling relation of critical current density depending on the magnetic field and magnetic field angle with wire is adopted in the model. AC loss contributions, including hysteresis and eddy current losses, are estimated in detail at 5-Hz magnetic field with amplitude range from 0.1 to 7 T. At low fields and 4.2 K temperature, hysteresis losses of quasi-isotropic strands are less than the eddy current losses (which mainly comes from the copper sheath), this situation is very different from the 77 K. Effects of the magnetic field frequency and orientation with a strand on ac losses are also particularly analyzed under different magnetic fields. The numerical results are helpful for overall understanding on ac loss characteristics of quasi-isotropic strands and are also useful for their applications in high magnetic field at low temperatures.
28 February 2019 in IEEE Transactions on Applied Superconductivity