1 November 2012 in Construction and Building Materials
1 April 2014 in ACI Materials Journal
1 July 2011 in Journal of Applied Sciences
1 January 2020 in IOP Conference Series: Materials Science and Engineering
The Marshall Mix design is one of the most widely used methods for designing and evaluating hot asphalt mixes globally, and the main Marshall Test focuses are stability and flow. Two standard curing methods are normally followed to elevate the temperature of testing samples; these involve immersing the samples in 60°C water or placing the samples in an oven at 60°C. These standard curing methods may not simulate the actual state of heating of asphalt pavement in the field, however. In this research, a new curing method that includes insulating the samples before immersion in hot water is thus introduced and compared with the two standard curing methods. During immersion, the water temperature is increased to 60°C and the core temperature of the insulated samples determined. Three sets of Marshall Samples were prepared and cured using the outlined methods; each set consisted of 18 specimens of 101 mm diameter and 63.5 mm height. All specimens were tested using the Marshall Test for stability, flow, and Marshall Stiffness. The set mean results showed that the oven cured samples demonstrated the highest stability values, followed by the standard water cured samples, while the insulated samples exhibited the lowest stability values. The oven cured samples also exhibited higher Marshall Stiffness Index (MSI) values than the other curing methods. However, one-way ANOVA (single factor) testing demonstrated that these differences were not statistically significant.
28 November 2017 in ARO-THE SCIENTIFIC JOURNAL OF KOYA UNIVERSITY
Thermal Effects on Compressive Strength of Local Limestone and Claystone
10 December 2019 in ARO-THE SCIENTIFIC JOURNAL OF KOYA UNIVERSITY
The possible biological hazards due to the mobile phone electromagnetic (EM) field exposure are caused mainly by a temperature rise in tissue. Hence, the calculation of temperature in tissue may be more realistic than the calculation of specific absorption rate (SAR) due to the more direct relationship between temperature and safety. The heat transfer to human tissue due to a phone call is caused by a combined effect of conductive heat transfer caused by the basic non-microwave-related activity of the mobile phone and the absorption of the microwave. This paper investigates the role of heat transfer in living tissue due to thermal conduction. This is achieved using a thermal imaging camera to measure and map the skin temperature distribution over human head due to mobile phone EM emission. Two commercial mobile phone brands, that is, Apple iPhone 7 Plus and Huawei P20 Pro, are used at 1800 MHz cellular connection and approximate radiated power of 0.125 W to measure the skin temperature over human head at both, cheek and tilt position for 6 and 30 min calls. The results show that in spite of the direct proportion between the deposited SAR and temperature increase in human tissues, the heat transfer due to thermal conduction may not directly proportional to the SAR, where other factors may play important roles, for example, mobile phone chassis material, heated battery, antenna location inside the mobile phone, and mobile phone position in close proximity to head.