1 November 2016 in Journal of the Brazilian Society of Mechanical Sciences and Engineering
11 January 2014 in The International Journal of Advanced Manufacturing Technology
4 December 2017 in Production Engineering
25 July 2015 in The International Journal of Advanced Manufacturing Technology
1 October 2014 in Advanced Materials Research
The design and manufacturing of complex shaped 3D features have a wide range of applications in todays manufacturing industries. With machining of hard materials continues to attract much interest in this field, EDM remains an indispensable process to carry out this purpose despite its limitations compared to conventional machining processes in terms of material removal rate and surface quality. Many process improvement techniques have been reported by researchers to overcome these limitations and out of them, incorporation of tool electrode kinematics is observed to have a significant effect. In the present investigation, an attempt has been made to study the effectiveness of two different tool motions in the generation of non-circular cavities. Tool electrode is moved on planetary and diagonal paths during this study. Effects of various electrical and non-electrical parameters on EDM responses have been studied. Current, pulse ON time and voltage are considered as the electrical parameters while tool kinematics parameters like tool path offset and scanning speed have been selected as the non-electrical parameters. Experiments have been carried out the study the effect of tool movement on planetary and diagonal path on different response characteristics viz. Material removal rateand Wear Ratio. It has been observed that planetary motion is a better strategy than diagonal motion for the generation of non-circular cavities in terms of achievement of the response characteristics. The results observed are critically discussed.
1 January 2015 in International Journal of Machining and Machinability of Materials
The effect of two orbital or planetary tool actuation strategies viz. helical and diagonal on tool wear rate during the generation of non-circular features is presented in the paper. Under both strategies, the effect of factors like tool path offset, scanning speed, current, gap voltage, pulse ON time and duty factor on the response have been studied in detail. Further, end condition of the tool electrodes used under different conditions has been studied and qualitatively compared. Among electrical factors, lower values of current, gap voltage and duty factor and higher values of pulse ON time are preferable for lower tool wear rate as well tool deformation. Tool motion factors viz. tool path offset and scanning speed is observed to have no significant effect on the response at lower discharge energy conditions. Analysis of experimental results suggests that helical strategy is preferable to diagonal strategy for the generation of non-circular cavities using EDM process.