1 January 2024 in Journal of Transportation Engineering, Part A: Systems
8 March 2024 in IET Intelligent Transport Systems
Connected and automated vehicles (CAVs) are being developed and designed to operate on existing roads. Their safe and efficient operation during roadworks, where traffic management measures are often introduced, is crucial. Two alternative measures are commonly applied during roadworks on motorways: (i) closing one or multiple lanes (ii) narrowing one or all lanes. The former can cause delays and increased emissions, while the latter can pose safety risks. This study uses a VISSIM‐based traffic microsimulation to compare the effectiveness of these two strategies on traffic efficiency and safety, considering various market penetration rates (MPR) of CAVs. The model was calibrated and validated with the data collected from M1 motorway in the United Kingdom. Results show that average delays per vehicle‐kilometre‐travelled decreased from 102.7 to 2.5 s (with lane closure) and 23.6 to 0.6 s (with narrow lanes) with 0% and 100% CAV MPR, respectively. Moreover, safety in narrow lanes improved by 4.8 times compared to 1.5 times improvement in lane closure with a 100% CAV MPR; indicating that narrow lanes would result in better safety performance. These findings could assist transport authorities in designing temporary traffic management measure that results in better CAV performance when navigating through roadworks.
17 October 2023 in IEEE Transactions on Intelligent Transportation Systems
Navigating through roadworks represents one of the main sources of safety risk for Connected and Autonomous Vehicles (CAVs) due to the altered road layouts. The built-in base maps do not normally reflect these changes, causing CAVs to experience difficulties in sensing and trajectory generation. Therefore, the objective of this paper is to evaluate different collision-free trajectory generation for CAVs at roadworks to improve safety and traffic performance. Trajectory generation algorithms using lane-level dynamic maps were examined for: 1) CAVs rely on data from in-vehicle sensor only; and 2) CAVs receive additional information via a Smart Traffic Cone (STC) in advance regarding roadwork configurations. Experiments were conducted at a controlled motorway facility operated by National Highways (England) using a vehicle instrumented with a suite of sensors. Schematics of the roadworks scenario were translated into an integrated simulation platform consisting of a traffic microsimulation (VISSIM) to simulate traffic dynamics and a sub-microscopic simulator (PreScan) capable of simulating vehicle autonomy and connectivity. Results indicate that traffic conflicts and delays decrease by 40% and 3% respectively when CAVs receive additional information in advance (i.e., Scenario 2) compared to the other scenario. These findings would assist road network operators in developing ‘CAV-enabled roadworks’ and vehicle manufacturers in designing a vehicle-based ‘roadworks assist’ system.