16 September 2026 in The Open Dentistry Journal
Introduction: Single-shade restorative resin composites simplify shade selection, but their color stability and response to whitening mouthrinses remain uncertain. This in-vitro study evaluated their staining susceptibility and subsequent color response. Materials and Methods: A total of 360 specimens (6 × 2 mm) were prepared from three single-shade restorative resin composites and one nanohybrid control. Specimens were immersed in distilled water, coffee, or red wine for 1 month (n = 30). They then underwent a 4-week protocol using one of two peroxide-free whitening mouthrinses (n = 15). Color was measured three times with a spectrophotometer at baseline, after immersion, and after mouthrinse application. CIEDE2000 color differences were analyzed using analysis of variance and multiple linear regression ( p < 0.05). Results: Material and immersion medium significantly affected color change ( p < 0.001). At 1 month, red wine caused the greatest change (12.74 ± 2.50 to 21.53 ± 1.99), followed by coffee (7.80 ± 2.35 to 13.88 ± 2.27); distilled water produced the lowest values. The response to mouthrinse application varied by material and medium. Residual color difference decreased in most red-wine groups but increased in some distilled-water and coffee groups. Complete color recovery was not achieved. Discussion: CDO was the most susceptible material, whereas OMN and ESQ were more resistant. Reduced lightness was the predominant component of staining. Conclusion: Staining and the response to mouthrinse application were material- and medium-dependent. Peroxide-free mouthrinses did not consistently reduce residual color differences across all experimental groups.
27 October 2026 in Scientific Reports
Single-shade resin-based composites (RBCs) are marketed as matching a wide range of tooth shades, although supporting evidence remains limited. This in vitro study evaluated the color-matching ability of Omnichroma (OMN), Vittra APS Unique (VTR), and Charisma Diamond One (DIA) against four shade backgrounds. Molds were fabricated from a conventional composite in A1, B1, JE, and BW shades, and standardized cavities were restored with each RBC (n = 15; 180 specimens). Color was measured using a clinical spectrophotometer. Two CIEDE2000 (ΔE₀₀) outcomes were calculated: polymerization-induced color change and the difference between the background mold and restored specimen. Data were analyzed using two-way ANOVA, followed by Welch's ANOVA and Games–Howell tests. Polymerization-induced ΔE₀₀ ranged from 3.31 to 10.18, differed among materials in three of the four shade backgrounds (p < 0.001), and exceeded the perceptibility (0.8) and acceptability (1.8) thresholds in all groups. Only VTR against JE produced clinically acceptable matching (1.29 ± 0.24), although the difference remained perceptible. All other combinations exceeded the acceptability threshold. Color matching was material- and background-dependent and poorest against the most chromatic backgrounds, indicating that universal color matching should not be assumed under the tested conditions.
14 November 2026 in BMC Oral Health