8 January 2015 in Polycyclic Aromatic Compounds
Occurrence and toxicity of polycyclic aromatic hydrocarbons (PAHs) have been extensively studied in countries all over the world. PAHs generally occur in complex mixtures which may consist of hundreds of compounds. The U.S. Environmental Protection Agency (EPA) proposed in the 1970 to monitor a set of 16 PAHs which are frequently found in environmental samples. This article reviews the suitability of the 16 EPA PAHs for the assessment of potential health threats to humans stemming from the exposure to PAHs by food ingestion. It presents details on analysis methods, the occurrence of PAHs in food, regulatory aspects, and related risk management approaches. In addition, consideration is given to newer evaluations of the toxicity of PAHs and the requirements for risk assessment and management stemming from them.
1 July 2006 in TrAC Trends in Analytical Chemistry
1 October 2003 in Food Additives & Contaminants
In early 2002, the Swedish National Food Administration reported high acrylamide levels in heat-treated carbohydrate-rich foods. Consequently, intensive activity began examining the many different types of food, and thousands of analyses have been undertaken world wide. Measurement data have been published in many different types of media. Within this flood of publications, there are only a limited number of articles concerned with the technical aspects of the measurements. This review focuses on the state-of-the-art in the analysis of acrylamide in foodstuffs. It covers information on methods from peer-reviewed articles and other sources (e.g. a survey carried out among official and private laboratories of the Member States of the European Union). Alternative methods are presented and discussed alongside the more common measurement techniques for acrylamide in foodstuffs. Special attention is given to sample preparation. The greatest differences between the analytical methods was for acrylamide extraction and clean-up. The influence of different extraction techniques or extraction solvents/solvent mixtures on the measurement results has not yet been fully investigated. There is also a lack of understanding about the sample clean-up. Since both might have a large impact on the results of the analysis, this review should also be considered as a basis for further investigations.
3 August 2007 in Analytical and Bioanalytical Chemistry
1 July 2007 in Food Additives & Contaminants
This paper summarizes the progress made in understanding the formation of acrylamide in coffee, as well as potential reduction strategies, as presented during the joint CIAA/EC workshop on acrylamide, held in Brussels in March 2006. Currently, there are no concrete measures to reduce acrylamide concentrations in roast and ground coffee without appreciably changing the organoleptic properties of the product. Certain approaches, such as steam roasting, have been tried on a laboratory scale, albeit without affording a significant reduction. More work on the mechanisms governing the “loss” of acrylamide during storage of roast and ground coffee is warranted, and studies in this direction have been initiated. Finally, risk/benefit analysis must be addressed in a complex food such as coffee, known to harbour numerous health beneficial/chemoprotective compounds with antioxidant and antimutagenic properties.
1 November 2015 in Journal of Chromatography A
Facing growing restrictions on the use of bisphenol A in food contact materials, several bisphenol analogs are arising as major alternatives to replace this chemical in most of its applications. This work reports a simple and robust method based on mixed-mode solid-phase extraction and stable-isotope dilution liquid chromatography-tandem mass spectrometry for the analysis of bisphenol A and its main analogs - bisphenol S, 4,4'-sulfonylbis(2-methylphenol), bisphenol F, bisphenol E, bisphenol B, bisphenol Z, bisphenol AF, bisphenol AP, tetrabromobisphenol A and bisphenol P - in alcoholic and non-alcoholic beverages. Mixed-mode solid-phase extraction, combining cationic exchange and reversed-phase mechanisms, was optimized to provide a selective extraction and purification of the target analytes. Derivatization of bisphenols with pyridine-3-sulfonyl chloride allowed increasing their ionization efficiency by electrospray ionization. Validation of the proposed method was performed in terms of selectivity, matrix effects, linearity, precision, measurement uncertainty, trueness and limits of detection. Satisfactory repeatability and intermediate precision were obtained; the related relative standard deviations were ≤9% and ≤12%, respectively. The relative expanded uncertainty (k=2) was below 20% for all bisphenol analogs and the trueness of the method was demonstrated by recovery experiments. Limits of detection (LOD) ranged from 1.6ngL(-1) to 27.9ngL(-1) for all compounds. Finally, several canned and non-canned beverages were analyzed to demonstrate the applicability of the method. Only bisphenol A and three bisphenol F isomers were detected in any of the samples. Bisphenol A concentration ranged from