Baoying Dou

Baoying Dou

Auto-generated profile, based on publicly available information

Baoying Dou

Henan University

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 April 2023 in Journal of the American Chemical Society
Verified
Journal Article
Closed access
ANAkira Nagaoka
Akira Nagaoka
KKKoji Kimura
Koji Kimura
AAArtoni Kelvin R. Ang
Artoni Kelvin R. Ang
YTYasuhiro Takabayashi
Yasuhiro Takabayashi
KYKenji Yoshino
Kenji Yoshino
KNKensuke Nishioka
Kensuke Nishioka

24 January 2022 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
TSTao Shen
Tao Shen
KYKaike Yang
Kaike Yang
BDBaoying Dou
Baoying Dou
SWSuhuai Wei
Suhuai Wei
YLYuanyue Liu
Yuanyue Liu
HDHui-Xiong Deng
Hui-Xiong Deng
ZnO and SnO2 are wide bandgap semiconductors, which have great potential for UV detectors, light emitting diodes, and other optoelectronic devices. The performance of these devices is significantly affected by exciton binding energies of oxides. Although bandgaps of ZnO and SnO2 are similar, their exciton binding energies differ by a large amount, because it was reported experimentally that the exciton binding energy of SnO2 is 130 meV, which is higher than that of ZnO with 60 meV. On the other hand, because ZnO has higher ionicity and a large overlap of electrons and hole wavefunctions, it is expected that it should have larger exciton binding energy than that of SnO2 [Dvorak et al., Phys. Rev. Lett. 110, 016402 (2013)]. Therefore, there is a controversy for relative magnitudes of the exciton binding energy between SnO2 and ZnO. Here, based on accurate GW + Bethe–Salpeter equation calculations, we clarify that the exciton binding energy of SnO2 is less than that of ZnO, following the general rule; therefore, more experimental study should be carried out to verify our predictions. We expect that this fundamental understanding of the relative magnitude of exciton binding energies will be useful for prospective applications of ZnO and SnO2 in optoelectronic devices.

16 May 2023 in Physical Review Applied
Verified
Journal Article
Closed access
PDF file
BDBaoying Dou
Baoying Dou
SFStefano Falletta
Stefano Falletta
JNJörg Neugebauer
Jörg Neugebauer
CFChristoph Freysoldt
Christoph Freysoldt
Xie ZhangXie Zhang
Xie Zhang
SWSuhuai Wei
Suhuai Wei
Nonradiative recombination in Cu(In,Ga)Se2 (CIGS) solar cells has long been attributed to the antisite defects MCu (M = In, Ga), but the underlying mechanism is still elusive. Using rigorous first-principles calculations, we demonstrate that the antisites themselves cannot capture holes and hence cannot lead to efficient carrier recombination. Instead, internal conversion in the neutral charge state to the distorted DX center configuration opens an efficient hole-capture pathway. After hole capture, the positive charge state returns to the normal antisite configuration without any barrier to complete the entire recombination cycle. Our results show that the DX center is thermally accessible in CuGaSe2, but not in CuInSe2, due to its rather low conduction-band minimum; thus, the recombination rate in CIGS is composition dependent. These insights clarify the nonradiative recombination mechanism in ternary chalcopyrites and provide a guideline for composition engineering to enable the optimal performance of CIGS solar cells.

20 May 2021 in Physical Review Applied
Verified
Journal Article
Closed access
PDF file
BDBaoying Dou
Baoying Dou
QSQingde Sun
Qingde Sun
SWSuhuai Wei
Suhuai Wei
Group-V substitution at the Te site, XTe (X = P, As, Sb), under Cd-rich conditions is an effective way to enhance the hole density and, in the meantime, suppresses the dominant nonradiative carrier recombination center in CdTe, thus, improving the performance of CdTe thin-film solar cells. However, it is not clear which group-V dopant, X, is the most effective dopant, because it is expected that PTe will have the shallowest acceptor level due to its high electronegativity, whereas SbTe will have the smallest formation energy due to its small size mismatch with Te. Our systematic first-principles study shows that the hole concentration contributed by the acceptor XTe− is limited by the related compensating AX+ center that increases simultaneously with XTe− as the chemical potential of dopant X increases. However, the ratio of XTe− acceptors to the AX+ donors can be significantly increased if the sample is grown at high temperature and then annealed to room temperature, achieving a high hole density and low Fermi level (EF). We find that all group-V (P, As, and Sb) dopings can achieve maximum hole densities of about 1017cm−3, which are consistent with previous experimental results. Despite the relatively deep acceptor level of 150 meV, Sb doping can achieve a considerable hole density due to the low formation energy of substituting Sb for Te with similar atomic radii. P doping can achieve a higher hole density than that of Sb due to its shallow transition energy at ε(0/−) = 70 meV. However, the highest hole density is achieved through As doping, which is attributed to its balanced defect level at ε(0/−) = 80 meV and relatively small formation energy.

7 December 2021 in Physical Review B
Verified
Journal Article
Closed access
PDF file
BDBaoying Dou
Baoying Dou
QSQingde Sun
Qingde Sun
SWSuhuai Wei
Suhuai Wei
Co-doping is an important method to improve doping properties in semiconductors, which is expected to lower the defect formation energy through the Coulomb interaction or covalent coupling between co-dopants and reduce the transition energy level through the level repulsions. However, the effectiveness of co-doping is sensitive to the type of co-dopants, and in some cases, negative effects can exist. Here, using p-type doping in CdTe as an example, we systematically investigate different dopant combinations based on first-principles hybrid functional calculations. We show that the complex of one donor + one double acceptor, e.g., ClTe+VCd, can cause a decrease in defect formation energy and a reduction in acceptor level, thus improving the dopability, especially when the Cl treatment is done at low temperature. The combination of two acceptors + one donor, e.g., ClTe+2CuCd, has little or even negative effects because of the coexistence of the acceptor-acceptor and donor-acceptor coupling. More importantly, we show that the combination of one deep acceptor + one shallow acceptor, e.g., SbTe+PTe, produces a much deeper acceptor level because the nominal deep acceptor SbTe acts as a donor with respect to the shallow one, and then the deep acceptor state will be pushed even deeper due to the level repulsion. Thus, we should avoid this type of acceptor-acceptor co-doping to achieve high hole concentration. Our general understanding of the co-doping approach, therefore, provides a guideline for the future design of shallow defect complexes in CdTe and other semiconductors.

20 May 2024 in Physical Review B
Verified
Journal Article
Closed access
PDF file
BDBaoying Dou
Baoying Dou
XCXuefen Cai
Xuefen Cai
SWSuhuai Wei
Suhuai Wei
Hole densities in group-V (P, As, and Sb) doped CdTe typically fall below 1017cm−3 although sufficient group-V dopants are incorporated. Previous theoretical studies suggested that the formation of AX centers compensates the acceptors, thereby limiting p-type doping. However, recent calculations including spin-orbit coupling effects suggest that AX centers are unstable and thus cannot hinder p-type doping. Therefore, the origin of the hole density pinning issue in CdTe remains elusive. Our first-principles calculations, incorporating spin-orbit coupling, coupled with detailed balance simulations, reveal that hole doping in CdTe remains significantly limited despite the instability of the AX centers. This limitation stems from the self-compensation driven by the native vacancies and the band-edge excitations induced by free carriers. Additionally, we find that As is the most favorable dopant among group-V dopants due to its relatively low formation energy and shallow transition level. Our understanding of the hole-limiting mechanism is important for improving the dopability of CdTe solar cells. Moreover, our analysis of the band-edge excitations is critical for describing the defect properties in semiconductors.