The rectangular channel louvered-fin compact heat exchanger (LFCHE) is the most efficient type that has been served in a radiator. However, with this type of heat exchanger, the pressure drop rises by three to four times as the heat transfer increases, which results in decreasing performance. This research is aimed to numerically investigate the louver edges (vertical, inclined, and horizontal) effect on LFCHE performance at different louver angle () with air inlet velocities ranging from 1 to 30 m/s. A total of twelve models are made and simulated. The result revealed that the horizontal edge decreases the pressure drop up to 24.2% with a 1.01% increase in outlet air temperature over the base model (inclined edge). Thus, louver edge has design which results in higher and lower effect on pressure drop and temperature change, respectively. The research investigated the effects of louver edges using different performance evaluation criteria. At 10 m/s ( = 972.33) the horizontal edge increases the volume goodness (jf) factor up to 21.49% over the base model. Similarly, the horizontal edged fins resulted in maximum increment of jf-factor by 22% and 25% as compared with inclined edge for louver angles of 24 (at low ) and 20 (at high ), respectively. Generally, the horizontally edged LFCHE is proven to have higher performance in cooling the coolant with a minimum air side pressure drop.
23 October 2025 in Case Studies in Thermal Engineering
This study investigates the effect of working fluid, operating frequency, regenerator design parameters (length, porosity, and wire diameter), and different losses on the performance of a Stirling heat pump. Helium and hydrogen are preferable working fluids because of their high thermal conductivity, which enhances heat transfer. Air and nitrogen are more readily available, but their lower thermal conductivity results in poor performance. In addition, the study demonstrates that the pressure drop work loss and the imperfect regenerator loss are the two major work and power losses, respectively. This study has been done by simulating the FEMTO-60 engine in reverse cycle under various operating and design conditions. Furthermore, the Particle Swarm Optimization method has been studied to select the best geometry and porosity of the regenerator of the heat pump to enhance the performance. The optimized regenerator of the heat pump increases the overall performance of the heat pump by 3.2 % at a working pressure of 17.5 bar,and 7.3 Hz operating frequency.