Trees produce different types of woody tissue during growth. The xylem produced in the first years until a certain cambial age is called juvenile wood and has different physical, mechanical, chemical and anatomical characteristics from that produced later, when the cambial cells have matured. Thus, prior knowledge of the quality of the wood is of fundamental importance for choosing the best use of the material. This work aimed at using data from length of the tracheid and wood density to define the age transition from juvenile to mature wood. For this, three Pinus elliottii var. elliottii trees, aged 35 years, were collected at the Itapetininga Experimental Station, located in the state of São Paulo, Brazil. From each tree, disks of about 5 cm thick were obtained 0.05 m above the ground and used to determine the radial density by the gamma ray attenuation method and to measure the length of the tracheids. The results obtained by linear regression analysis showed that juvenile wood is limited to the first seven years of tree growth and the formation of mature wood occurs after twenty years. For the mature wood, there are significant differences among the averages obtained from the tracheid length and wood density
This study aimed to evaluate surface roughness of heat treated Eucalyptus grandis wood after peripheral planning and sanding performed in directions to the grain and against the grain. For machining tests, workpieces were collected from two different regions in the radial direction, as follows: internal, nearby the pit; external, nearby the bark. Heat treatment was carried out by heating samples at a maximum temperature of 190ºC, with total treatment duration of 390 minutes. Heat treated and control samples underwent peripheral planning and sanding tests. The quality of machined surfaces was assessed by means of roughness average (Ra) measurements across and along the grain orientation. Results indicated significant differences in surface roughness as a function of machining feed direction, sandpaper grit size, and heat treatment. Surface roughness has not shown any difference in the radial direction.
The poor management and marketing of rose pepper (Schinus terebinthifolius Raddi) in São Pedro D'Aldeia - RJ called the local governments’ attention to adopt measures that favor the value chain, increase income, train rural producers, and launch the first Simplified Forest Management Plan. All of this, to authorize the sustainable management of this species. This study aimed to evaluate the quality parameters of pink pepper as sustainability indicators. The following was measured: the moisture content, purity, uniformity in the sieve, and the weight of one thousand seeds in samples obtained from three different batches. The germination test was only carried out for samples from lot 3. The results showed that the high moisture content of the seeds (22.99%) has a negative effect on their quality, facilitating the action of spoilage organisms. The degree of purity was satisfactory (97.1%). The seeds from lot 1 were larger and more uniform than the seeds from lots 2 and 3. Only lot 1 presented the weight of seeds compatible with that required by MAPA. The germination rate was 72%, which did not vary between seeds of different sizes. The settlement’s extractive activity is moving towards sustainability, which can be improved by incorporating good seed collection, processing and storage practices.
Http://dx.doi.org/10.5902/1980509817472O objetivo deste estudo foi estudar a qualidade da superfície usinada da madeira de Eucalyptus grandis, submetida ao processo de tratamento térmico. As operações de usinagens realizadas nas tábuas obtidas a partir do processamento de mecânico de seis árvores foram: desempeno, desengrosso, rasgo na furadeira horizontal, furação, furação para dobradiça e lixamento. Foram selecionadas 208 tábuas de 125 x 25 x 500 mm, sendo 104 não tratadas e 104 tratadas termicamente a uma temperatura final de 190ºC. A avaliação da superfície foi feita de acordo com a norma ASTM D-1666/87. O resultado mostrou que a madeira de Eucalyptus grandis apresenta um bom comportamento durante os testes de usinagem, obtendo notas 1 e 2 (excelente e bom), exceto para os testes de furação para a dobradiça no furo passante e furação com broca de 12, 8 e 6 mm, pois alcançaram notas entre 2 e 4 (bom, regular e ruim). O tratamento térmico diminuiu a quantidade de defeitos nas amostras usinadas, com exceção para o defeito grã arrancada, em algumas operações de usinagem.
Seeds of native forest species for food and seedling production have a growing demand that impacts the need for studies involving seed storage in order to maintain good levels of germination quality. Thus, scientific analyzes that explore the physiological potential of the seeds of these species are necessary, especially for the pink pepper (Schinus terebinthifolia Raddi.), a species used as an alternative source of income for traditional communities and which has been arousing interest due to the consumption of its fruits as a condiment in the national and international market. This work aimed to assess the physiological quality of pink pepper seeds according to the storage period and seed size. The seeds came from a rural settlement, a pioneer in the extraction of pink pepper, in the state of Rio de Janeiro, Brazil. The seeds were evaluated for moisture content, germination, first count, length and dry weight of the germinated seedlings, during the period of time that they remained stored and the size of the seeds. The results allowed to conclude that: i) the germinative percentage of the stored pink pepper seeds decreased over the months; ii) the moisture content of the seeds decreased over the months evaluated iii) the different sizes of seeds did not show differences in germination and storage time and iv) values of length and dry weight of the seedlings did not differ according to the period of storage.