1 September 2021 in KSCE Journal of Civil Engineering
Reinforcing structural members and construction materials using recycled fibers has become popular in the past decades due to sustainable development concerns. The recycled fibers as soil reinforcement elements contribute to the increase in shear strength by distributing stresses exerted in the soil along the length of the recycled fibers. Loess, widely spread over the Chinese Loess Plateau, is featured with metastable structure, large porosity, and high water sensitivity. This study presents the results of applying the large-scale stress-controlled direct shear tests on the recycled straw fiber-reinforced loess. The formation mechanism of shearing behaviour enhancement of the loess by straw fiber inclusion is revealed. The associated strain-hardening behaviour can be manifested using the dilation angle or the difference in friction angle between the large-displacement friction angle and the peak friction angle. Further, the shear strength using the displacement-controlled direct shear tests presents good correspondence with that using the stress-controlled direct shear tests. The test results explore the potential of using the recycled straw fiber-reinforced loess to protect the fragile loess environment in the northwest of China.
1 September 2020 in Tunnelling and Underground Space Technology
1 December 2020 in Journal of Geotechnical and Geoenvironmental Engineering
Tunneling-induced ground movements can affect the equilibrium state of an existing pile, causing uneven settlement among pile groups and damage to connected structures. This paper presents results from five centrifuge tests aimed at evaluating the load redistribution mechanisms that occur within piles located close to tunnel excavation. Two main mechanisms are studied: first, those related to ground displacements and stress relief related to tunneling and, second, those related to pile head load changes caused by connected superstructures (accomplished using a hybrid centrifuge-numerical modeling method). A novel fiber Bragg grating sensor system was used to measure shaft shear stresses along model piles. Results are used to quantify the relative impact that these two mechanisms have on pile load redistribution during tunnel volume loss. In addition, posttunneling pile loading tests were performed, with results indicating that tunneling-induced ground volumetric strains could influence the posttunneling loading response of piles.
9 March 2023 in Computers and Geotechnics
1 December 2021 in Computers and Geotechnics
1 November 2021 in Journal of Geotechnical and Geoenvironmental Engineering
Preliminary estimations of shaft resistance of rock-socketed piles are usually conducted using empirical formulations that relate to the uniaxial compressive strength ( ) of the weaker material involved (intact rock or pile). However, there are other factors, such as the degree of socket roughness, that could affect the shaft resistance of rock-socketed piles. In this paper, results from geotechnical centrifuge tests are presented to demonstrate the effect of socket roughness on the pile shaft resistance. Aluminum model piles with different degrees of shaft roughness were fabricated and embedded within an artificial rock mixture composed of sand, cement, bentonite, and water. Pile loading tests were conducted within the centrifuge and axial forces along the model piles were measured using fiber Bragg grating (FBG) sensing technology. Results are used to demonstrate that centrifuge testing provides a suitable experimental method to study and quantify the effect of socket roughness on the shaft shearing mechanism of rock-socketed piles. Finally, the centrifuge test measurements are compared with several formulations published in the literature, suggesting that centrifuge measurements tend to agree with the overall trend, despite the variability of predictions obtained with different formulations.