20 March 2019 in Transport in Porous Media
17 June 2023 in Applied Ocean Research
1 November 2020 in Journal of Building Engineering
1 June 2021 in Proceedings of the Institution of Civil Engineers - Construction Materials
The classical models describing hygric transport inside building materials seem unsuitable for bio-based materials. Based on the assumption of an instantaneous local equilibrium between relative humidity and water content evolving according to the sorption isotherms, they predict much shorter stabilisation times than those obtained experimentally. A new approach is presented here: it frees from the local instantaneous equilibrium by introducing local kinetics to describe the transformation of water from the vapour state to the absorbed liquid state and vice versa. In the framework of the European IsoBio project, a multilayered wall mainly made of bio-based materials was developed. The different layers were characterised in terms of sorption, vapour permeabilities and thermal conductivities. The sorption measurements performed on representative samples allowed determination of the local kinetic constants. The hygrothermal behaviour of the test wall was then studied in an instrumented demonstrator (Hive, Wroughton, UK). The recorded measurements were compared with simulations based on the instantaneous local equilibrium model (TMC code) and on the local kinetics of sorption model (TMCKIN code). TMC very significantly underestimated the dynamics of the local relative humidity variations whereas TMCKIN succeeded in predicting these dynamics and produced results close to measurements.
22 July 2025 in European Journal of Environmental and Civil Engineering
1 February 2017 in Journal of Applied Meteorology and Climatology
This study addresses the modeling of the denebulization (i.e., the removal of droplets) of warm fogs (T ≥ 0°C) by hygroscopic salt microparticles from the initial seeding at the top of the fog layer to the fall of the rain droplets on the ground. Two main phenomena can occur: condensation of water vapor on salted droplets and the concomitant evaporation of fog droplets, and coalescence between the salted droplets and the fog droplets. Three salts have been investigated: NaCl, CaCl2, and KCl. Based on the conservation equations, the modeling approach (1D) considers the hygroscopicity of the salts through the water activity in the aqueous solution and the coalescence induced by gravity and turbulence. From this study, NaCl is the most efficient salt in the tested operating conditions. Actually, this result can be explained by the strong hygroscopicity of this salt in very dilute solutions. From the calculations, 15 kg of NaCl particles of 6.7-μm diameter can dissipate a typical fog layer of 40 m in height within less than 17 min over 0.25 km2. According to the calculations, a fog layer of 100 m in height can be denebulized within 45 min. The contribution of the coalescence induced by gravity and by turbulence seems to have a negligible effect on the final horizontal visibility, the condensation/evaporation phenomena being preponderant for these operating conditions.