Application of surfactants in the remediation of polluted sites with dense nonaqueous phase liquid (DNAPL) still requires knowledge of partitioning between surfactants and pollutants in the organic and aqueous phases and the time necessary to reach this balance. Two real DNAPLs, generated as wastes in the lindane production and taken from the polluted sites from Sabiñanigo (Spain), were used for investigating the solubilization of 28 chlorinated organic compounds (COCs) applying aqueous surfactant solutions of three nonionic surfactants (E-Mulse® 3 (E3), Tween®80 (T80), and a mixture of Tween®80-Span®80 (TS80)) and an anionic surfactant (sodium dodecyl sulfate (SDS)). The initial concentrations of surfactants were tested within the range of 3–17 g·L−1. The pH was also modified from 7 to >12. The uptake of nonionic surfactants into the organic phase was higher than the anionic surfactants. Solubilization of COCs with the nonionic surfactants showed similar molar solubilization ratios (MSR = 4.33 mmolCOCs·g−1surf), higher than SDS (MSR = 0.70 mmolCOCs·g−1SDS). Furthermore, under strong alkaline conditions, the MSR value of the nonionic surfactants was unchanged, and the MSR of SDS value increased (MSR = 1.32 mmolCOCs·g−1SDS). The nonionic surfactants did not produce preferential solubilization of COCs; meanwhile, SDS preferentially dissolved the more polar compounds in DNAPL. The time required to reach phase equilibrium was between 24 and 48 h, and this contact time should be assured to optimize the effect of the surfactant injected on COC solubilization.
13 January 2022 in Journal of Environmental Management
Sites polluted by dense non-aqueous phases (DNAPLs) constitute an environmental concern. In situ chemical oxidation (ISCO) application is limited since oxidation often occurs in the aqueous phase and contaminants are usually hydrophobic. In this work, ISCO enhanced by the surfactant addition (S-ISCO) was studied for a complex liquid mixture of chlorinated organic compounds (COCs) using persulfate (PS) activated by alkali (PSA) as oxidant and Emulse-3® as a commercial non-ionic surfactant. The reaction between E3 and PSA was investigated in the absence and presence of solubilized COCs in the following concentration ranges: COCs 1.2-50 mM, PS 84-336 mM, NaOH:PS molar ratio of 2, and surfactant concentration 1-10 g·L-1. In the experiments carried out in the absence of COCs, the unproductive consumption of PS was studied. The higher the surfactant concentration, the lower the ratio PS consumed to the initial surfactant concentration due to more complex micelle structures hindering the oxidation of surfactant molecules. This hindering effect was also noticed in the oxidation of solubilized COCs. The reduction of chlorobenzenes by PSA was negligible at surfactant concentrations above 2.5 g·L-1, independently of the COCs concentration solubilized. Instead, a surfactant concentration of about 1 and PS concentration of 168 mM yielded a significant decrease in the time required to abate a mass of DNAPL, compared with an ISCO process, with a bearable increase in the unproductive consumption of PS.
Sardas Landfill at Sabiñánigo Huesca is polluted with Dense Non-Aqueous Liquid Phases (DNAPLs) composed of a complex mixture of chlorinated organic compounds (COCs). This DNAPL was produced as liquid waste from lindane production being dumped decades ago in the unlined landfills close to the lindane factory. This DNAPL migrated by gravity through the subsurface and accumulated in the contact between the alluvial and marls layers (about 15 m b.g.l.). Seven injections of an aqueous emulsion of a biodegradable non-ionic surfactant (E-Mulse 3®) were carried out at the most polluted areas of the Sardas alluvial. Injections were carried out between April and November 2021 using different surfactant concentrations (6.7, 20, 25 and 50 g/L), injection volumes (0.2 to 7 m3) and injection flow rates (0.08–0.85 m3/h). Injected fluids were extracted in the same well or surrounding wells, and the time elapsed between surfactant injection and extraction varied between 24 and 72 h. A total of 22 m3 were injected into the alluvial, and more than double this injected volume was extracted. Injection and extraction points were in the contact between the marls and the alluvial layer. Extracted fluid accumulated in tanks, and phases separated. DNAPL recovered here was mobilized rather than solubilized and managed as toxic waste. The aqueous supernatant was treated in a wastewater treatment plant with physicochemical treatment (including adsorption in activated carbon) before being discharged into the environment. The transport of the injected fluids was monitored by conductivity profiles using bromide (260–538 mg·L−1) as a conservative tracer. High radial dispersion of the injected fluid was found. Surfactant losses by adsorption in the alluvial and absorption in DNAPL were noticed, and both surfactant and contamination did not escape from the capture zone. Monitoring since 2018 of the COCS in groundwater and the DNAPL presence in the contact between alluvial and marls layers showed a significant reduction of COCs in the treated zone with the surfactant injections.
21 June 2025 in Separation and Purification Technology