George Brinklow

George Brinklow

Auto-generated profile, based on publicly available information

George Brinklow

Department of Mechanical Engineering, School of Engineering, University of Birmingham, Birmingham, UK

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 November 2024 in International Journal of Hydrogen Energy
Verified
Journal Article
Open access
MWM. Wu
M. Wu
ACA. Cova-Bonillo
A. Cova-Bonillo
PGPedro Gabana
Pedro Gabana
GBG. Brinklow
G. Brinklow
NKN.D. Khedkar
N.D. Khedkar
AYAndrew York
Andrew York

23 February 2023 in International Journal of Environmental Science and Technology
Verified
Journal Article
Open access
PDF file
GBG. Brinklow
G. Brinklow
JHJ. M. Herreros
J. M. Herreros
SRS. Zeraati Rezaei
S. Zeraati Rezaei
ODO. Doustdar
O. Doustdar
ATA. Tsolakis
A. Tsolakis
PMP. Millington
P. Millington
Transport sector decarbonisation is leading to increased demand for electrified powertrains including hybrid vehicles. The presence of an internal combustion engine and electric motor offer multiple performance and efficiency advantages. However, changes in the conditions that catalytic aftertreatment systems are subjected to can present challenges in meeting forthcoming emissions standards. This work investigated the three-way catalyst performance to abate regulated and unregulated emissions from a gasoline direct injection engine working under conditions related to hybrid vehicle operation. The focus on unregulated emissions of NH3 and N2O is of interest due to limited literature on their formation in conventional, and particularly hybrid, vehicle aftertreatment systems. Furthermore, the likelihood of their regulation when the EURO 7 emissions standards are introduced increases the pertinence of this work. For this particular engine and aftertreatment setup, it was found that starting the engine whilst the three-way catalyst temperature was below 150 ℃ led to an increase in tailpipe regulated emissions and N2O. Whilst, starting the engine when three-way catalyst temperatures were above 350 ℃ lead to tailpipe NH3 emissions. This was due to the selectivity of NO to form N2O at lower temperatures and NH3 at higher temperatures. For the case of the studied catalyst, a vehicle energy management strategy opting to start the engine with the three-way catalyst within a targeted temperature range allowed for a trade-off between regulated emissions, N2O and NH3. These findings are significant since it can be used to optimise hybrid vehicle control strategies minimising both regulated and unregulated emissions.

21 October 2025 in International Journal of Hydrogen Energy
Verified
Journal Article
Open access
Alexis Jose Cova-BonilloAlexis Jose Cova-Bonillo
Alexis Jose Cova-Bonillo
PGPedro Gabana
Pedro Gabana
NKN. Khedkar
N. Khedkar
GBG. Brinklow
G. Brinklow
MWM. Wu
M. Wu
JHJ. Hall
J. Hall

10 April 2025 in Automotive Innovation
Verified
Journal Article
Open access
PDF file
GBGeorge Brinklow
George Brinklow
JHJose Martin Herreros
Jose Martin Herreros
SZSoheil Zeraati-Rezaei
Soheil Zeraati-Rezaei
ATAthanasios Tsolakis
Athanasios Tsolakis
PMPaul Millington
Paul Millington
AKAmy Kolpin
Amy Kolpin
Stricter CO2 and local air quality targets are increasing the demand for electrified powertrains including hybrid electric vehicles (HEVs). The impact of an electrified vehicle powertrain on the catalytic performance of the emissions control system presents the challenge of multiple cold/warm starts during vehicle operation. This work investigates advanced energy efficient technologies to understand and enhance the catalytic reduction of primary and secondary emissions under challenging HEV operation conditions. A novel strategy based on the concept of engine cylinder deactivation is experimentally studied at various starting catalyst temperatures aiming to reduce the time required to reach catalyst light-off temperature and thus tailpipe emissions. Unregulated secondary emissions (NH3 and N2O) are also investigated, which are expected to become more pertinent in the future. This work demonstrates that operating under the studied strategy for a short period of time increased TWC temperature by up to 300 °C and reduced mass-based emissions of CO, NO, HCs, N2O and NH3. These findings are significant to inform the optimization of energy efficient catalyst heating strategies for HEVs in order to reduce both primary and secondary emissions.

3 October 2025 in Fuel
Verified
Journal Article
Open access
AWA. Wahbi
A. Wahbi
GBG. Brinklow
G. Brinklow
ACA. Cova-Bonillo
A. Cova-Bonillo
MWM. Wu
M. Wu
ATA. Tsolakis
A. Tsolakis
RBR. Blight
R. Blight

26 October 2025 in Proceedings of the Institution of Mechanical Engineers, Part P: Journal of Sports Engineering and Technology
Verified
Journal Article
Open access
RJRosie Joslin
Rosie Joslin
GBGeorge Brinklow
George Brinklow
Modern, open-wheeled racing cars rely heavily on downforce generated by underbody Venturi tunnels to gain a competitive advantage. While these tunnels are critical to aerodynamic efficiency, their interaction with other components - particularly the rear wing - remains an area worth exploring. This study uses computational fluid dynamics (CFD) to investigate how changing the rear wing’s angle of attack (AoA), defined as the angle between the wing’s chord line and the oncoming airflow, vertical and longitudinal position influences the aerodynamic performance of the underbody and total downforce production. CFD allows for detailed analysis of pressure distribution and flow behaviour, offering insight into how the rear wing affects the efficiency of the Venturi tunnels. Results show that it is important to analyse the underbody and rear wing, both as a system and as separate components, because their individual behaviours do not always reflect their combined effect. In addition, the longitudinal position of the rear wing had the largest impact on the underbody’s performance when compared to the AoA and vertical position. Shifting the rear wing’s position from 5.0 to 5.1 m resulted in an increase in the underbody’s − C L from 1.55 to 2.00. These findings can help engineers to understand better the aerodynamic relationship between the rear wing and underbody, aiding the development of higher-performing race cars. In a competitive motorsport environment where small aerodynamic gains can make a big difference, refining these interactions is key to improving handling, lap times, and sporting performance.