The use of side brushcutters exposes users to vibration and noise, which can cause damage to the operator, as they act as a stressor agent. Excessive vibration is responsible for countless disorders, including Raynaud’s syndrome. This study aimed to assess the effect of the vibrations of a side brush cutter on the human body. A side brush cutter was used with three cutting implements (double blade, triple blade and double nylon thread) applied to two crops (wheat and ryegrass). The vibration was measured through a three-dimensional accelerometer placed on the handgrips of the brush cutter, in compliance with the provisions of the ISO 5349-1 Standard. The analyzed variables were submitted to the Shapiro-Wilk and Bartlett tests. Due to the abnormality, the data were transformed by the Neperian logarithm and submitted to analysis of variance, and the means were compared by the Tukey test at 5% probability. As a result, the orthogonal y-axis presented a higher vibration level; the three-point blade showed the lowest vibration level compared to the other cutting implements for both crops; these vibration levels did not exceed the NHO10 recommendation. Hence, using the appropriate attachment for each operation may reduce the harm caused by vibration to the operator’s body.
Sound power is a fundamental parameter for characterizing noise sources. This report described the methodology applied to characterize an outdoor environment for determining the sound power levels of portable hand-held machines based on sound pressure measurements. To achieve this objective, the procedures followed ISO 3744:2010 and ABNT NBR ISO 22868:2023. In addition, measurements were performed using a Solo (01dB) sound level meter. The results show that background noise levels remained below the applicable correction limits for both frequency bands above 160 Hz and overall levels. The environmental correction factor was 1.7 dB(A). Sound power levels were 90.4 and 106.2 dB(A) for the chainsaw, and 85.2 and 104.7 dB(A) for the brush cutter, corresponding to idling and full-load conditions, respectively. Therefore, the negligible influence of background noise and an environmental correction factor below 2 dB(A) confirm the suitability of the test site and support the reliability of the sound power levels determined for the evaluated sources.