30 September 2019 in Nuclear Science and Techniques
18 December 2020 in IEEE Transactions on Applied Superconductivity
Superconducting 499.8-MHz radio frequency (rf) cavities have been proposed for the High Energy Photon Source (HEPS), a 6-GeV diffraction-limited synchrotron light source currently under construction in Beijing. Being an active third-harmonic system, two cavities shall provide 3.5-MV rf voltage and 400 kW of beam power to enable a complex rf gymnastics required by a novel injection scheme. Adopting the veteran KEKB-type 500-MHz single-cell geometry, the cavity design has been focused on optimizing its mechanical properties. Various cavity wall thickness and external stiffening mechanisms were investigated to reinforce the cavity to ensure compliance to the pressure vessel codes under different working conditions from a bare cavity to a dressed cavity in the cryomodule. Small margins on operational pressure previously reported on this type of cavity have been largely improved with slightly reduced yet acceptable frequency tunability. Extensive design optimizations have been conducted aiming for lower stress, larger elastic buckling pressure, and higher frequencies of mechanical modes to cause microphonics, while the frequency tunability, pressure sensitivity, and Lorentz force detuning were being carefully monitored. In view of the HEPS’s lifetime, cavity fatigue was examined. This constitutes a comprehensive design optimization of the 499.8-MHz single-cell superconducting cavity with improved mechanical properties.
8 May 2021 in Nuclear Science and Techniques
1 May 2016 in Chinese Physics C
4 November 2019 in Radiation Detection Technology and Methods
1 November 2015 in Chinese Physics C
In accelerator RF cavities, there exists not only the fundamental mode which is used to accelerate the beam, but also higher order modes (HOMs). The higher order modes excited by the beam can seriously affect beam quality, especially for the higher R/Q modes. 1.3 GHz low-loss 9-cell superconducting cavity as a candidate for ILC high gradient cavity, the properties of higher order mode has not been studied carefully. IHEP based on existing low loss cavity, designed and developed a large grain size 1.3 GHz low-loss 9-cell superconducting cavity (IHEP02 cavity). The higher order mode coupler of IHEP02 used TESLA coupler's design. As a result of the limitation of the mechanical design, the distance between higher order mode coupler and end cell is larger than TESLA cavity. This paper reports on measured results of higher order modes in the IHEP02 1.3 GHz low-loss 9-cell superconducting cavity. Using different methods, Qe of the dangerous modes passbands have been obtained. The results are compared with TESLA cavity results. R/Q of the first three passbands have also been obtained by simulation and compared with the results of the TESLA cavity.