19 September 2017 in IEEE Transactions on Antennas and Propagation
A technique for the synthesis of shaped beam radiation patterns is proposed. The new synthesis method is based on superposition principle and Taylor method. The method may control the sidelobe level of the shaped beam. The approach includes four steps: 1) get the distribution of pencil beam array with low sidelobe by Taylor method; 2) let the beams scan as a phased array to the specific angles according to the requirement of the shaped beam, The sum pattern is close to the shaping beam; 3) determine the value of angles and weights; and 4) count the distribution of the shaped beam array according to the new array factor function. Numerical results are provided to assess the capabilities of the proposed design method. The method develops an effective approach for the synthesis of shaped beams via uniform linear arrays. Both the ripple and sidelobe level of shaped beam may be controlled by the new synthesis method.
29 March 2017 in IEEE Transactions on Antennas and Propagation
In this communication, a novel broadband dual circularly polarized (CP) antenna is presented. This antenna consists of an U-shaped slot to achieve broadband CP radiation and two 50-Ω microstrip-fed ports to realize both right-hand circular polarization and left-hand circular polarization at the same frequency band. The axial ratio bandwidth (ARBW) is greatly broadened by moving the feeding ports to upper portion of the U-shaped slot. To verify this design, the proposed antenna is fabricated and measured. The measured -10 dB reflection coefficient bandwidth is about 114.4% (1.80-6.61 GHz) and the 3-dB ARBW is approximately 110.5% (1.83-6.35 GHz). The isolation between two ports is better than 14.8 dB within the ARBW.
29 May 2020 in IEEE Antennas and Wireless Propagation Letters
In this letter, a low-profile circularly polarized (CP) reconfigurable printed antenna array employing switching circuits are reported. To realize low-profile design, an artificial magnetic conductor (AMC) reflector is adopted and loaded at the bottom of the antenna element. Furthermore, in order to meet the high gain and wide bandwidth requirements of S-band satellite communication systems, a 2x4 antenna array is also designed. The proposed antenna array has advantages in three aspects: small size with low profile, polarization diversity and high radiation efficiency. With this method, this antenna array is simulated, fabricated, and tested with reasonable agreement between measurement and simulation.
1 December 2021 in IEEE Antennas and Wireless Propagation Letters
A broadband wide-angle scanning array antenna with suppressed mutual coupling for 5G Sub-6G mobile communication applications is presented in this letter. To reduce mutual coupling, the metal columns are used in the dipole array antenna. The metal columns are positioned below the edge of the dipole, leading to the improved the impedance matching characteristics and a wider scanning angle. A 18 prototype of the suggested design has been manufactured and tested to ensure its usefulness. The overall dimension is 2.3300.2800.240 (0 is the free space wavelength at 2.5 GHz). The measured and simulated results are quite consistent. The main lobe achieves a scanning range of 60 at 2.5-4.5 GHz (57.1%, active VSWR<2) and yields a scanning range of 75 at 3-4 GHz (28.6%, active VSWR<2) with a gain loss of less than 2.5 dB. In the meantime, the side lobe levels (SLLs) are mostly less than or equal to -7.9 dB and the isolation between the antenna elements can yield a maximal additional 14.7 dB enhancement.
24 September 2018 in IEEE Transactions on Antennas and Propagation
In this paper, a synthesis method for shaped beam pattern of two-dimensional array antenna is proposed. The method is based on the array scanning principle and the superposition principle. The method can limit the ripple of main beam by adjusting the sampling point interval and can easily achieve low sidelobe level. Compared to the stochastic optimization methods, this method has obvious time advantage when it is used to synthesize large array antenna. The factors that affect the sidelobe level, ripple and Dynamic Range Ratio is discussed. Sparse array is used to reduce Dynamic Range Ratio.
24 September 2020 in IEEE Transactions on Antennas and Propagation
The generation process of difference beam is analyzed from the perspective of beam superposition. By analyzing the continuous linear source, a differential beam synthesis method, which can control the side-lobes level, is proposed with a simple form. The side-lobes level of the difference pattern is determined by controlling the direction of the sub-beam and applying the traditional synthesis method, such as Chebyshev method and Taylor method. The proposed synthesis method is theoretical and explicit. Examples are presented for assessing the capabilities of the synthesis of difference patterns. The general distribution function is given.