6 October 2009 in Chemical Society Reviews
Over the past two decades, membrane processes have gained a lot of attention for the separation of gases. They have been found to be very suitable for wide scale applications owing to their reasonable cost, good selectivity and easily engineered modules. This critical review primarily focuses on the various aspects of membrane processes related to the separation of biogas, more in specific CO2 and H2S removal from CH4 and H2 streams. Considering the limitations of inorganic materials for membranes, the present review will only focus on work done with polymeric materials. An overview on the performance of commercial membranes and lab-made membranes highlighting the problems associated with their applications will be given first. The development studies carried out to enhance the performance of membranes for gas separation will be discussed in the subsequent section. This review has been broadly divided into three sections (i) performance of commercial polymeric membranes (ii) performance of lab-made polymeric membranes and (iii) performance of mixed matrix membranes (MMMs) for gas separations. It will include structural modifications at polymer level, polymer blending, as well as synthesis of mixed matrix membranes, for which addition of silane-coupling agents and selection of suitable fillers will receive special attention. Apart from an overview of the different membrane materials, the study will also highlight the effects of different operating conditions that eventually decide the performance and longevity of membrane applications in gas separations. The discussion will be largely restricted to the studies carried out on polyimide (PI), cellulose acetate (CA), polysulfone (PSf) and polydimethyl siloxane (PDMS) membranes, as these membrane materials have been most widely used for commercial applications. Finally, the most important strategies that would ensure new commercial applications will be discussed (156 references).
15 March 2010 in Journal of Membrane Science
1 September 2011 in Journal of Membrane Science
1 November 2013 in Journal of Membrane Science
1 April 2011 in Journal of Membrane Science
30 July 2012 in Journal of Materials Chemistry
Mixed matrix membranes (MMMs) composed of sulfonated aromatic poly(ether ether ketone) (SPEEK) and –SO3 functionalized mesoporous MCM-41 were prepared by the solution casting method. A SPEEK polymer with a fixed degree of sulfonation was used for membrane synthesis. CO2 permeation data and SEM images of the synthesized MMMs suggest that the functionalized fillers adhered well to the polymer matrix. Gas permeation tests indicated that the addition of functionalized MCM-41 to the polymer matrix increased both the gas permeability and selectivity. The highest selectivities obtained here for CO2/N2 and CO2/CH4 were 40.46 and 22.86 (at a CO2 permeability of 21.04 Barrer), respectively. In order to initiate the evaluation of the practical commercial viability of these membranes, they were tested under different operating pressures and temperatures.