1 December 2007 in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
Most tactile displays currently built rely on pin-based arrays. However, this kind of tactile device is not always appropriate when we need to give the illusion of finely textured surfaces. In this paper, we describe the squeeze film effect between a plate and a finger, and we use this effect to design an ultrasonic tactile plate. The plate is actuated by piezoelectric ceramics. Ultrasonic vibrations are thus produced and are capable of generating the squeeze film effect. This enables us to simulate variable friction on the surface of the plate. In order to identify the squeeze film phenomenon, this study considers the case where a finger, with a planar bottom surface and with epidermal ridges, is placed on a rapidly vibrating plate. The overpressure is calculated and the result enables us to assess the relative coefficient of friction as a function of the vibration amplitude of the plate. Based on this principle, and using both analytic and FE method studies, and given ergonomic and stimulation (squeeze film) requirements, we show that it is possible to design a tactile plate which is capable of giving programmable tactile sensations. We conclude by comparing the results obtained from our simulations with experimental results.
18 December 2017 in IEEE Transactions on Industrial Electronics
This paper presents the implementation of a novel vibration amplitude control and resonant frequency tracking for piezoelectric transducers (PTs) and ultrasonic motors (USMs). It is based on a generalization of the vector control method to the PT and the USM, which is explained in the first part. We show that two independent controllers with a similar structure are required: one tracks the resonant frequency and the second controls the amplitude. We then present the implementation into a low-cost digital signal processing controller with a sampling period of 200 μs. Experimental results on a Langevin transducer achieved a time response of 20 ms approximately, and the generality of the method is further demonstrated on a 2-D tactile stimulator at the end of this paper.
1 July 2013 in Sensors and Actuators A: Physical
23 July 2007 in IEEE Transactions on Industry Applications
In this paper, precise position control of a traveling-wave ultrasonic motor is achieved, avoiding the traditional drawbacks attributable to nonlinear torque generation, which are overshoot or slow response time. For that purpose, a behavior model control is proposed and presented. With this control law, a quick and precise response is obtained. In this paper, we present a position-control scheme of an inertial load. The guideline used for this control was a rotation of 90 in a response time of about 200 ms with a position error of 0.6 mrad, targeting a typical application for avionics. In this paper, a Shinsei USR30 is used, but the method can be applied to other ultrasonic motors.