24 July 2001 in Physical Review Letters
nuclear magnetic resonance experiments are reported on a series of fully strained epitaxial thin films on . We have found evidence of multiple phase segregation into ferromagnetic metallic and nonmetallic regions as well as regions that are nonferromagnetic and insulating. These insulating regions are mainly located close to interfaces and may have a significant impact on the performance of spin-tunnel devices. As a result of phase segregation, the ferromagnetic coupling within the metallic regions is depressed. This accounts for the reduction of the Curie temperature and conductivity in nanometric thin films.
17 February 2006 in Journal of Physics D: Applied Physics
21 October 2002 in Physical Review B
We have studied the thickness dependence of the magnetotransport properties of thin films epitaxially grown on and single-crystalline substrates. When thickness decreases, a global disruption of the magnetoelectronic properties occurs, namely the resistivity and the low-temperature magnetoresistance increase while the metal-to-insulator transition temperature is lowered. We state that the electronic properties of these films, especially close to the film/substrate interface, differ from those of the bulk material. This is confirmed by nuclear-magnetic-resonance measurements which provide evidence that these films have an inhomogeneous magnetoelectronic nanostructure with distinguishable regions containing localized charges. These regions are scattered within the films, with a higher density close to interfaces in the case of films on but more homogeneously distributed for films grown on Since our manganite films have a virtually unrelaxed crystal structure, the thickness dependence of can neither be related to the strain states nor to dimensional effects. Alternatively, we show that the coexistence of different electronic phases leads to a modification of the carrier density in the metallic regions and, presumably, to an enhancement of the disorder in the Mn-O bond length and Mn-O-Mn angles. We will argue that the conjunction of both factors promotes a decrease of the double exchange transfer integral and, consequently, accounts for the reduction of the Curie temperature for the thinnest films. The possible mechanisms responsible for this phase separation are discussed in terms of the microstructure of the interfaces between the manganite and the insulating perovskite.
18 December 2007 in Physical Review B
We report on the structural and magnetic characterization of (110) and (001) (LCMO) epitaxial thin films simultaneously grown on (110) and substrates, with thicknesses varying between 8 and . It is found that while the in-plane interplanar distances of the (001) films are strongly clamped to those of the substrate and the films remain strained up to well above , the (110) films relax much earlier. Accurate determination of the in-plane and out-of-plane interplanar distances has allowed concluding that for nm, unit cell volume expansion does not change substantially for (001) films whereas it relaxes towards bulk value for (110) ones. However, in all cases, an abnormal unit cell expansion is observed for nm. It is observed that the magnetic properties (Curie temperature and saturation magnetization) of the (110) films are significantly improved compared to those of (001) films. These observations, combined with -nuclear magnetic resonance data and x-ray photoemission spectroscopy, signal that the depression of the magnetic properties of the more strained (001)LCMO films is not caused by an elastic deformation of the perovskite lattice but rather due to the electronic and chemical phase separation caused by the substrate-induced strain. On the contrary, the thickness dependence of the magnetic properties of the less strained (110)LCMO films are simply described by the elastic deformation of the manganite lattice. We will argue that the different behavior of (001) and (110)LCMO films is a consequence of the dissimilar electronic structure of these interfaces.
16 July 2003 in Physical Review B
Stacking faults are found to play a crucial role in the evolution of the structural and magnetic properties of cobalt subjected to ball milling. This has been evidenced by using complementary techniques, i.e., magnetometry and torque measurements, nuclear magnetic resonance (NMR) and x-ray diffraction (XRD). After short milling times a stacking-fault driven transformation from fcc to hcp cobalt is observed, which is accompanied by an increase of the effective magnetic anisotropy, the NMR restoring field and the coercivity. The results suggest that small amounts of stacking faults can be beneficial to enhance the coercivity in hexagonal Co. For longer milling times, both XRD and NMR results show that the hcp phase becomes heavily distorted because of the large amount of stacking faults accumulated. This induces a decrease of the magnetic anisotropy, which leads to the overall softening of the material.
19 June 2008 in Physical Review B
The local structures around Co atoms in (, 0.5, and 1.0) Heusler alloys have been investigated using NMR spin-echo method and their effect on the tunneling magnetoresistance for the junctions using electrodes has been discussed. The NMR spectra of the Heusler alloys are extremely sensitive to the site disorder and clearly distinguish among the , , and structures providing quantitative information on the amount of disorder. The tunnel magnetoresistance for the junctions is demonstrated to be sensitive to the site disorder in electrodes.