Takashi Komine

Takashi Komine

Auto-generated profile, based on publicly available information

Takashi Komine

Ibaraki University

Research Focus & Metrics

Academic Career Length

32Years (1995-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 September 2010 in Review of Scientific Instruments
Verified
Journal Article
Open access
PDF file
YHYasuhiro Hasegawa
Yasuhiro Hasegawa
DNDaiki Nakamura
Daiki Nakamura
MMMasayuki Murata
Masayuki Murata
HYHiroya Yamamoto
Hiroya Yamamoto
TKTakashi Komine
Takashi Komine
We describe a method for precisely controlling temperature using a Gifford–McMahon (GM) cryocooler that involves inserting fiber-reinforced-plastic dampers into a conventional cryosystem. Temperature fluctuations in a GM cryocooler without a large heat bath or a stainless-steel damper at 4.2 K are typically of the order of 200 mK. It is particularly difficult to control the temperature of a GM cryocooler at low temperatures. The fiber-reinforced-plastic dampers enabled us to dramatically reduce temperature fluctuations at low temperatures. A standard deviation of the temperature fluctuations of 0.21 mK could be achieved when the temperature was controlled at 4.200 0 K using a feedback temperature control system with two heaters. Adding the dampers increased the minimum achievable temperature from 3.2 to 3.3 K. Precise temperature control between 4.200 0 and 300.000 K was attained using the GM cryocooler, and the standard deviation of the temperature fluctuations was less than 1.2 mK even at 300 K. This technique makes it possible to control and stabilize the temperature using a GM cryocooler.

1 June 2006 in Physica B: Condensed Matter
Verified
Journal Article
Closed access
YHY. Hasegawa
Y. Hasegawa
YIY. Ishikawa
Y. Ishikawa
TST. Saso
T. Saso
HSH. Shirai
H. Shirai
HMH. Morita
H. Morita
HNH. Nakamura
H. Nakamura

1 June 2009 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
MMMasayuki Murata
Masayuki Murata
DNDaiki Nakamura
Daiki Nakamura
YHYasuhiro Hasegawa
Yasuhiro Hasegawa
TKTakashi Komine
Takashi Komine
TTTakashi Taguchi
Takashi Taguchi
JHJos Heremans
Jos Heremans
A limiting mean free path was considered in order to better understand the temperature and wire diameter dependence of the resistivity and Seebeck coefficient of bismuth microwire and nanowire samples. The mean free path limited mobility was numerically calculated from experimentally measured mobility in a bulk bismuth sample, and the electron and hole mobilities were dramatically decreased to a 10 μm mean free path. Therefore, the temperature dependence of resistivity in very thin wire was quite different from that of a bulk sample, which had a positive temperature coefficient. The calculations showed that the temperature coefficient decreased gradually with decreasing mean free path, and the coefficient became negative for a mean free path of less than 1 μm at about 150 K. The Seebeck coefficient was also calculated, but showed only a weak dependence on mean free path compared with the resistivity. Experimental comparisons were made to previous measurements of bismuth microwire or nanowire samples, and the temperature and wire diameter dependencies of the resistivity and Seebeck coefficient were qualitatively and quantitatively in very good agreement. Therefore, the temperature dependencies of nanowire samples over 850 nm in diameter were well described using the mean free path limitation.

12 January 2016 in Physical Review B
Verified
Journal Article
Open access
PDF file
KSKazuo Saito
Kazuo Saito
HSHirokatsu Sawahata
Hirokatsu Sawahata
TKTakashi Komine
Takashi Komine
TATomosuke Aono
Tomosuke Aono
The surface spin states for bismuth thin films are investigated using an sp3 tight-binding model. The model explains most experimental observations using angle-resolved photoemission spectroscopy, including the Fermi surface, the band structure with Rashba spin splitting, and the quantum confinement in the energy band gap of the surface states. A large out-of-plane spin component also appears. The surface states penetrate inside the film to within approximately a few bilayers near the Brillouin-zone center, whereas they reach the center of the film near the Brillouin-zone boundary.

1 April 2011 in Review of Scientific Instruments
Verified
Journal Article
Closed access
DNDaiki Nakamura
Daiki Nakamura
YHYasuhiro Hasegawa
Yasuhiro Hasegawa
MMMasayuki Murata
Masayuki Murata
HYHiroya Yamamoto
Hiroya Yamamoto
FTFumiaki Tsunemi
Fumiaki Tsunemi
TKTakashi Komine
Takashi Komine
Modeling and experiments are performed to decrease temperature fluctuation generated by the periodic motion of the displacer in a Gifford–McMahon (GM) type cryocooler within the low-temperature region. The one-dimensional heat equation allows us to show that thermal diffusivity is an essential factor to achieve much smaller temperature fluctuation, and fiber-reinforced plastic (FRP) with low thermal diffusivity makes it possible to reduce the temperature fluctuation dramatically. Based on the model, experiments are performed to vary the thickness of two FRP dampers, on the cryohead of the cryocooler and on the sample stage. As a result, the FRP dampers enable us to achieve the temperature fluctuations of only 0.7 mK, corresponding to a standard deviation of 0.25 mK, when the sample stage is maintained at 4.2000 K, even if a GM cryocooler is utilized for cooling the temperature, which introduces an initial temperature fluctuation of 282 mK at the cryohead.

11 May 2009 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
MMMasayuki Murata
Masayuki Murata
DNDaiki Nakamura
Daiki Nakamura
YHYasuhiro Hasegawa
Yasuhiro Hasegawa
TKTakashi Komine
Takashi Komine
TTTakashi Taguchi
Takashi Taguchi
JHJos Heremans
Jos Heremans
Bismuth nanowires with lengths of over 1 mm length and diameters of the order of nanometers have been fabricated by high-pressure injection into a quartz template. The temperature dependences of the Seebeck coefficient and resistivity were simultaneously measured over the temperature range of 77–300 K. The Seebeck coefficient and resistivity at 300 K were estimated to be approximately −57 μV/K and 1.31 μΩ m , respectively. We also estimated the mobilities of electrons and holes to determine their temperature dependences. We found that the temperature dependence of the resistivity can be accounted for by the reduction in the mobility.