9 October 2018 in IEEE Vehicular Technology Magazine
27 June 2019 in IEEE Transactions on Wireless Communications
In this paper, a deep learning (DL)-based sphere decoding algorithm is proposed, where the radius of the decoding hypersphere is learned by a deep neural network (DNN). The performance achieved by the proposed algorithm is very close to the optimal maximum likelihood decoding (MLD) over a wide range of signal-to-noise ratios (SNRs), while the computational complexity, compared to existing sphere decoding variants, is significantly reduced. This improvement is attributed to DNN’s ability of intelligently learning the radius of the hypersphere used in decoding. The expected complexity of the proposed DL-based algorithm is analytically derived and compared with existing ones. It is shown that the number of lattice points inside the decoding hypersphere drastically reduces in the DLbased algorithm in both the average and worst-case senses. The effectiveness of the proposed algorithm is shown through simulation for high-dimensional multiple-input multiple-output (MIMO) systems, using high-order modulations.
14 August 2019 in IEEE Journal on Selected Areas in Communications
We consider the use of deep neural network (DNN) to develop a decision-directed (DD)-channel estimation (CE) algorithm for multiple-input multiple-output (MIMO)-space-time block coded systems in highly dynamic vehicular environments. We propose the use of DNN for k -step channel prediction for space-time block code (STBC), and show that deep learning (DL)-based DD-CE can remove the need for Doppler rate estimation in fast time-varying quasi stationary channels, where the Doppler rate varies from one packet to another. Doppler rate estimation in this kind of vehicular channels is remarkably challenging and requires a large number of pilots and preambles, leading to lower power and spectral efficiency. We train two DNNs which learn the real and imaginary parts of the MIMO fading channels over a wide range of Doppler rates. We demonstrate that by these DNNs, DD-CE can be realized with only priori knowledge about Doppler rate range and not the exact value. For the proposed DD-CE algorithm, we also analytically derive the maximum likelihood (ML) decoding algorithm for STBC transmission. The proposed DL-based DD-CE is a promising solution for reliable communication over vehicular MIMO fading channels without accurate mathematical models. This is because DNNs can intelligently learn the statistics of the fading channels. Our simulation results show that the proposed DL-based DD-CE algorithm exhibits lower error propagation compared to existing DD-CE algorithms which require perfect knowledge of the Doppler rate.
8 October 2021 in IEEE Transactions on Wireless Communications
Existing wireless communication systems have been mainly designed to provide substantial gain in terms of data rates. However, 5G and Beyond will depart from this scheme, with the objective not only to provide services with higher data rates. One of the main goals is to support massive machine-type communications (mMTC) in the Internet-of-Things (IoT) applications. Supporting massive uplink communications for devices with sporadic traffic pattern and short-packet size, as it is in many mMTC use cases, is a challenging task, particularly when the control signaling is not negligible in size compared to the payload. In addition, channel estimation becomes challenging for sporadic and short-packet transmission due to the limited number of employed pilots. In this paper, a new uplink multiple access (MA) scheme is proposed for mMTC, which can support a large number of uncoordinated IoT devices with short-packet and sporadic traffic. The proposed uplink MA scheme removes the overheads associated with the device identifier as well as pilots and preambles related to channel estimation. An alternative mechanism for device identification (DI) is employed, where a unique spreading code is dedicated to each IoT device as identifier. This unique code is simultaneously used for the spreading purpose and DI. Two IoT DI algorithms which employ sparse signal reconstruction methods are proposed to determine the active IoT devices prior to data detection. Specifically, the Bayesian information criterion model order selection method is employed to develop an IoT DI algorithm for unknown and time-varying activity rate. Our proposed MA scheme benefits from a new non-coherent nonlinear multiuser detection algorithm designed on the basis of unsupervised machine learning techniques to enable data detection without a priori knowledge on channel state information. For performance improvement, an extension to multiple receive antennas through hard decision combining is proposed. The effectiveness of the proposed MA scheme for known and unknown activity rate and high overloading factor is supported by simulation results.
4 September 2020 in IEEE Communications Letters
The fundamental tradeoff between low latency and high reliability makes the design of ultra-reliable low-latency communications (URLLC) wireless systems challenging. To support URLLC for a fixed bandwidth, faster-than-Nyquist (FTN) signaling is a promising approach since it increases the degrees of freedom (i.e., channel uses) per time interval, which can be exploited to improve reliability. In this letter, we derive analytical expressions for the approximate maximum channel coding rate (MCCR) for finite blocklength FTN signaling for water-filling and equal power allocations. We show that for practical nonsinc square-root Nyquist pulses, the penalty on the rate incurred due to the finite blocklength can be significantly reduced by nonorthogonal FTN transmission. Our results reveal that the MCCR for finite blocklength FTN signaling exceeds the Shannon capacity achieved for infinite blocklength and orthogonal transmission.
7 June 2024 in IEEE Transactions on Aerospace and Electronic Systems
A cooperative Sense and Avoid (SAA) algorithm for safe navigation of small-sized UAVs within an airspace is proposed in this paper. The proposed method relies upon cooperation between the UAV and the surrounding transponder-equipped aviation obstacles. To do so, the aviation obstacles share their altitude and identification code with the UAV by using the Mode S operation of the Secondary Surveillance Radar (SSR) after interrogation. The proposed SAA algorithm benefits from the estimate of the aviation obstacle's elevation angle for ranging. This results in more accurate ranging compared to the round-trip time-based ranging, which is currently used in existing SAA systems. We also propose a low-complexity and accurate radial velocity estimator for the Mode S operation of the SSR which is employed in the proposed SAA system. Furthermore, by considering the Pulse-Position Modulation (PPM) of the transponder reply as a waveform of pulse radar with random pulse repetition intervals, the maximum unambiguous radial velocity is obtained. The proposed SAA is equipped with an intruder identification method that determines the risk level of the surrounding transponder-equipped aviation obstacles. Given the estimated parameters, the intruder identification method classifies the aviation obstacles into high- medium-, and low-risk intruders. The output of the classifier enables the UAV to plan its path or maneuver for safe navigation accordingly. The root mean square error (RMSE) of the proposed estimators are analytically derived, and the effectiveness of our SAA solution is confirmed through simulation experiments.