29 January 2021 in IEEE Journal of Solid-State Circuits
This article reports on the first demonstration of distributed amplifier monolithic microwave integrated circuits (MMICs) with a bandwidth (BW) of more than 300 GHz. The three presented circuits utilize a uniform traveling-wave amplifier topology with six, eight, and ten unit cells, respectively. In this article, the impact of the connection between the gate line and the transistors on the achievable performance is investigated. It is demonstrated that a short connection clearly provides a more favorable combination of BW, input matching, and losses on the gate line. Thus, it is possible to extend the BW beyond 300 GHz while utilizing transistors with a gate width of 2×10 μm. The MMICs are fabricated in a 35-nm gate-length InGaAs metamorphic high-electron-mobility transistor technology. The MMIC with six unit cells exhibits a noise figure (NF) between 3.5 and 8.2 dB for a noise-optimized bias from 1 GHz up to the measurement limit of 308 GHz. The MMIC with ten unit cells achieves a minimum NF of 2 dB for frequencies of around 50 GHz and stays below 10 dB for the entire band. Furthermore, for a power-optimized bias, the same circuit generates an output power between 8.7 and 14.8 dBm for a frequency range from 1 to 250 GHz.
14 December 2017 in IEEE Transactions on Microwave Theory and Techniques
This paper reports on the investigation, design, and fabrication of single-pole double-throw (SPDT) millimeter-wave integrated circuit (MMIC) switches for applications with an operating frequency of up to 330 GHz. An analysis of the well-established millimeter-wave (mmW) switch topology (λ/4-shunt SPDT switch) is done to achieve wideband performance and high isolation simultaneously. Using a standard technology parameter (Ron), this theory allows a performance estimation of switch MMICs before a wafer run and can support the design of mmW switches. Based on this analysis, a novel switch topology, with an improved isolation, is introduced. Additionally, this paper demonstrates three SPDT switch MMICs (SPDTs 1-3), the first two of which are targeting the W-band, whereas the latter is targeting the H-band frequency range. All MMICs were fabricated on the Fraunhofer Institute for Applied Solid State Physics 50-nm gate length metamorphic high-electron-mobility transistor process. SPDT 1 achieves a bandwidth of 52-168 GHz. The average insertion loss (IL) and the isolation are 3.1 and 42.1 dB, respectively. The peak performance is 2.1 and 52 dB. SPDT 2 utilizes the novel switch topology and yields the average IL and isolation of 4.5 and 56.4 dB, respectively. The operating bandwidth is 75-170 GHz. The peak performance is 3 and 65 dB. The 1-dB compression points (Pin1,dB) of SPDTs 1 and 2 are 19 dB and 14 dBm, respectively. SPDT 3 operates from 122 to 330 GHz and achieves the average IL and isolation of 2.2 and 17.4 dB, respectively. The peak performance is 1.5 and 22.8 dB.
23 December 2021 in IEEE Transactions on Microwave Theory and Techniques
This article reports on a gallium-nitride (GaN) low-noise amplifier (LNA) monolithic microwave integrated circuit (MMIC) with a 3-dB gain bandwidth (BW) from 63 to 101 GHz. The MMIC is fabricated in the Fraunhofer IAF 70-nm GaN-on-silicon-carbide (SiC) high-electron-mobility transistor (HEMT) technology. The four-stage common-source LNA exhibits an average noise figure (NF) of 3 dB for a measured frequency range from 75 to 101 GHz. The MMIC reaches a minimum NF of 2.8 dB at an operating frequency of 83 GHz. A mapping of two 100-mm wafers shows an excellent homogeneity with an 86% yield and an average NF of 3–3.3 dB. At 100 GHz, the LNA obtains output-referred 1-dB compression and third-order intercept points of 12.1 and 14.4 dBm, respectively. Furthermore, comprehensive investigations of the bias dependence of all measured performance parameters provide an insight into the presented device and LNA. To the best of the authors’ knowledge, this MMIC demonstrates the lowest NF among GaN LNAs at ${E}/{W}$ -band frequencies.
17 June 2021 in IEEE Transactions on Microwave Theory and Techniques
This article reports on the investigation and optimization of cryogenic noise mechanisms in InGaAs metamorphic high-electron-mobility transistors (mHEMTs). HEMT technologies with a gate length of 100, 50, and 35 nm are characterized both under room temperature and cryogenic conditions. Furthermore, two additional technology variations with 50-nm gate length are investigated to decompose different noise mechanisms in HEMTs. Therefore, cryogenic extended Ku-band low-noise amplifiers of the investigated technologies are presented to benchmark their noise performance. Technology C with a 50-nm gate length exhibits an average effective noise temperature of 4.2 K between 8 and 18 GHz with a minimum of 3.3 K when the amplifier is cooled to 10 K. The amplifier provides an average gain of 39.4 dB at optimal noise bias. The improved noise performance has been achieved by optimization of the epitaxial structure of the 50-nm technology, which leads to low gate leakage currents and high gain at low drain current bias. To the best of the authors' knowledge, this is the first time that an average noise temperature of 4.2 K has been demonstrated in the Ku-band.