In this work, the enzymatic synthesis of pentyl acetate obtained from acetic acid and pentan-1-ol using the commercial immobilized lipase Lipozyme®435 was studied. Specifically, the effects of several variables of the process on the kinetics were shown, such as the initial concentration of the acetic acid, the alcohol/acid molar ratio, and the possible reuse of the enzyme, while other variables, such as temperature, agitation, and the enzyme/acid ratio were held constant. The kinetics were determined by assessing the acetic acid concentration throughout the reactive process. Experimental data were correlated with the rate equation consisting of a modified version of the Bi–Bi Ping-Pong mechanism. The results showed that when no hydrophobic solvents were used with the reagents in stoichiometric proportion, a high molar fraction of acetic acid (x0,acid ≈ 0.50) caused the loss of enzymatic activity, achieving a conversion of only 5%. However, when there was an excess of pentan-1-ol, the reaction occurred successfully. Under optimal conditions (solvent-free conditions, x0,alcohol/x0,acid = 2, and x0,acid = 0.33), it was found that the enzyme could be reused up to 10 times without a loss of activity, reaching conversions higher than 80% after 8 h. Therefore, those conditions are advantageous in terms of productivity.
5 April 2020 in Industrial & Engineering Chemistry Research
This work presents an investigation on phase equilibria in partially miscible systems comprised of water, esters, and alkanols. Experimental liquid–liquid equilibria (LLE) were determined for ternaries of water+H2u–1Cu–1CO2CvH2v+1+CwH2w+1(OH) (u = 3,4; v = 2,3; w = 1–4) at 298.15 K and for the four corresponding water+ester binaries, in the temperature interval T = [283–328] K. The results reveal a complex behavior of the ternary LLE. The ester barely dissolves in the aqueous phase, even in the presence of alkanol (xmax,esterII ≈ 0.15). However, the organic phase contains high quantities of water when the compositions approach the plait point (xmax,waterI ≈ 0.75). Data modeling was carried out with a multiparametric model, obtaining an acceptable correlation with a maximum deviation in the compositions of sx = 0.031 for the system water(1)+propyl butanoate(2)+propan-1-ol(3). Estimations with COSMO-RS and UNIFAC differed from experimental values in all cases, especially in the systems containing propan-1-ol, since both models predict a nonreal immiscibility at 298.15 K in the binary water+propan-1-ol. Therefore, the simulation of the extractive process using UNIFAC was not adequate.
This work provides density data (~1300 values) of 14 alcohols with up to five carbon atoms at p ∈ [0.1–40] MPa and T ∈ [278–358] K. The information obtained is modeled with a convenient reformulation of the Tait equation from which the volumetric coefficients, α and β, are derived both analytically and numerically. The general EoS containing α and β is also used for checking the consistency of the hypothesis on the invariability of the cited thermophysic parameters. The results obtained can be considered reliable because of the low estimated errors between the experimental data and those of the literature, which are below 0.4% for volume, while for the volumetric coefficients there is always a reference diverging 10%, or less, from the proposed model estimations. By including the averages of α and β into the general state of equation the errors increase, being <15%, compared to those based on the Tait equation. Hence, the assumption on the stability of the volumetric coefficients in this working interval is sufficient to make rough estimations of the molar volume of the selected alcohols.
23 July 2025 in Industrial & Engineering Chemistry Research