This article presented a physics-based structural health monitoring (SHM) approach applied to a pretensioned adjacent concrete box beams bridge in order to predict the deformations associated with the presence of transient loads. A detailed finite element model was generated using ANSYS software to create an accurate model of the bridge. The presence of concentrated loads on the deck at different locations was simulated, and a static analysis was performed to quantify the deformations induced by the loads. Such deformations were then compared to the strains recorded by an array of wireless strain gauges during a controlled truckload test performed by an independent third party. The test consisted of twenty low-speed crossings at controlled distances from the bridge parapets using a truck with a certified load. The array was part of a SHM system that consisted of 30 wireless strain gauges. The results of the comparative analysis showed that the proposed physics-based monitoring is capable of identifying sensor-related faults and of determining the load distributions across the box beams. In addition, the data relative to near two-years monitoring were presented and showed the reliability of the SHM system as well as the challenges associated with environmental effects on the strain reading. An ongoing study is determining the ability of the proposed physics-based monitoring at estimating the variation of strain under simulated damage scenarios.
11 April 2020 in Journal of Civil Structural Health Monitoring
Three pretensioned adjacent concrete box beam bridges were studied with a structural health monitoring (SHM) paradigm based on strain measurements and finite element static analyses. An accurate model for one bridge and an approximate model for the other two were created using ansys software. The analyses were used to calculate the strains generated by six concentrated loads that mimic the presence of a truck. Pristine and damage scenarios were implemented, and the associated numerical strains were compared to the experimental strains measured with proprietary wireless sensors during a truck test. As the results from the approximate models deviated significantly from the field response of the bridge, the accurate model applied to one bridge was extended to the other two. The comparison between numerical and experimental results revealed the presence of noncritical anomalies related to strain distribution across adjacent beams. Such issues were confirmed with the examination of the historical strains streamed for several months to a repository, using simple data processing strategies. The intellectual contribution of the work resides in the combination of finite element analysis and SHM applied to three existing bridges with very similar structural characteristics. This combination revealed the presence of noncritical issues impossible to be diagnosed with conventional inspection.
Three Pennsylvanian bridges were studied using finite element and wireless sensor technology. A detailed finite element model of each bridge was created using a commercial software in order to calculate the strains generated by a load that simulates the presence of a standard truck. Pristine and damage scenarios were simulated, and the computed strains were compared to the experimental strains measured with proprietary wireless sensors during a truck test performed by companies not involved in the study presented in this article. The comparison demonstrated the accuracy of the model and the presence of a few non-critical anomalies in terms of load redistribution. In addition, the comparison proved the reliability of the wireless sensing system installed on the bridges, although some drift was observed. The structural monitoring program for the three bridges was also evaluated by processing more than two years of data streamed to a repository.