The California Bearing Ratio (CBR) of weakly expansive soil is specially relevant to its expansibility. The mechanisms affecting the bearing strength, in terms of the CBR, of weakly expansive soil that could be used as embankments filler are worth studying. In the present study, the effects of compaction energy on the compaction characteristics and CBR value were investigated. Additionally, the pore size distributions of soils with different compaction degrees were studied with nuclear magnetic resonance (NMR), and the effect of freeze–thaw cycles on the pore size distribution of soils with different compaction degrees was considered. Subsequently, the mechanisms influencing the CBR were analyzed at both the macroscale and microscale. A linear relationship between the CBR value and compaction degree was determined, characterizing the gradual variation of expansive soils with different moisture contents. With increasing freeze–thaw cycles, the volume of micropores decreased and mesopores increased, causing the CBR value to decrease. The expansion was a dominant factor for the CBR values. The CBR values rose with an increase in micropores and decreased with an increase in pore volume. It was considered that the tested weakly expansive soil could be used as an embankment filler in frozen areas.
Granite residual soil is one of the most frequently encountered problem soils in tropical regions, whose mechanical behavior heavily depends on the pattern of variation of mean effective stress (p’) during shearing, which can be classified into three categories: increasing-p’, constant-p’, and decreasing-p’. Unfortunately, so far, the stress–strain strength characteristics of granite residual soils have been studied mainly under increasing-p’ stress paths, although it is very likely to encounter stress paths with decreasing p’ in practice, especially in excavation engineering. Moreover, most pertinent research has focused on remolded granite residual soils, whereas undisturbed specimens have not yet received enough attention. In this paper, stress path triaxial tests considering different patterns of variation of mean effective stress were conducted on an undisturbed granite residual soil. Subsequently, a variable termed loading angle was introduced to quantitatively represent stress path. The influences of stress path on the Mohr–Coulomb strength parameters, deformation characteristics, ductility, and shearing stiffness were analyzed, with an emphasis on the role of pattern of variation of mean effective stress. The experimental results show that friction angle of the soil increases while cohesion decreases with the increase in loading angle. The increase in loading angle leads to less volume contraction and smaller failure strain. During shearing, the soil exhibited a less brittle response under stress paths with smaller loading angles. The initial secant shear modulus first decreased and then increased as the loading angle increased, with the minimum shearing stiffness occurring at a certain loading angle lying between 90° and 123.7°.
The cyclic stresses in subgrade soil induced by traffic loads are three-dimensional—cyclic major, intermediate, and minor principal stresses. To investigate the permanent deformation of natural undisturbed clay under three-dimensional cyclic stresses, a series of undrained true triaxial tests was carried out, using a true triaxial apparatus that could apply cyclic major, intermediate, and minor principal stresses simultaneously. The emphasis was on the effects of the cyclic stress ratio (CSR), the coefficient of cyclic intermediate principal stress (bcyc), and the reciprocal slope of the stress path in the p–q plane (ξ) on the permanent deformation characteristics. The test results show that bcyc reduces the accumulation of permanent major principal strain remarkably. For given values of the number of loading cycles (N), CSR, and ξ, decreases approximately linearly with increasing bcyc. ξ also limits the accumulation of . Furthermore, the ratio of for a given value of ξ to for ξ = 1 decreases from 1.095 to 0.887 when ξ increases from 0.67 to 1.5, and the relationship between and ξ is described by a linear formula. A critical value of bcyc is observed at which changes from tension to compression, that is, is zero at the critical value of bcyc. The difference among the critical values of bcyc in all the tests is relatively small, and the mean critical value of bcyc is 0.328. Moreover, an empirical formula is established for predicting the permanent major principal strain under three-dimensional cyclic stresses.
1 July 2024 in International Journal of Geomechanics