Carlo Bianco

Dr. Carlo Bianco

Politecnico di Torino
orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 2021 in Science of The Total Environment
Verified
Journal Article
Closed access
APAmelia Piscitello
Amelia Piscitello
Carlo BiancoCarlo Bianco
Carlo Bianco
ACAlessandro Casasso
Alessandro Casasso
RSRajandrea Sethi
Rajandrea Sethi

26 April 2022 in Journal of Hazardous Materials
Verified
Journal Article
Open access
GPGerardo Pulido-Reyes
Gerardo Pulido-Reyes
LMLeonardo Magherini
Leonardo Magherini
Carlo BiancoCarlo Bianco
Carlo Bianco
RSRajandrea Sethi
Rajandrea Sethi
UGUrs von Gunten
Urs von Gunten
DMDenise M. Mitrano
Denise M. Mitrano
Microplastics detected in potable water sources and tap water have led to concerns about the efficacy of current drinking water treatment processes to remove these contaminants. It is hypothesized that drinking water resources contain nanoplastics (NPs), but the detection of NPs is challenging. We, therefore, used palladium (Pd)-labeled NPs to investigate the behavior and removal of NPs during conventional drinking water treatment processes including ozonation, sand and activated carbon filtration. Ozone doses typically applied in drinking water treatment plants (DWTPs) hardly affect the NPs transport in the subsequent filtration systems. Amongst the different filtration media, NPs particles were most efficiently retained when aged (i.e. biofilm coated) sand was used with good agreements between laboratory and pilot scale systems. The removal of NPs through multiple filtration steps in a municipal full-scale DWTP was simulated using the MNMs software code. Removal efficiencies exceeding 3-log units were modeled for a combination of three consecutive filtration steps (rapid sand filtration, activated carbon filtration and slow sand filtration with 0.4-, 0.2- and 3.0-log-removal, respectively). According to the results from the model, the removal of NPs during slow sand filtration dominated the overall NPs removal which is also supported by the laboratory-scale and pilot-scale data. The results from this study can be used to estimate the NPs removal efficiency of typical DWTPs with similar water treatment chains.

1 October 2016 in Journal of Contaminant Hydrology
Verified
Journal Article
Open access
Carlo BiancoCarlo Bianco
Carlo Bianco
Tiziana ToscoTiziana Tosco
Tiziana Tosco
RSRajandrea Sethi
Rajandrea Sethi
Engineered nanoparticles (NPs) in the environment can act both as contaminants, when they are unintentionally released, and as remediation agents when injected on purpose at contaminated sites. In this work two carbon-based NPs are considered, namely CARBO-IRON®, a new material developed for contaminated site remediation, and single layer graphene oxide (SLGO), a potential contaminant of the next future. Understanding and modeling the transport and deposition of such NPs in aquifer systems is a key aspect in both cases, and numerical models capable to simulate NP transport in groundwater in complex 3D scenarios are necessary. To this aim, this work proposes a modeling approach based on modified advection-dispersion-deposition equations accounting for the coupled influence of flow velocity and ionic strength on particle transport. A new modeling tool (MNM3D - Micro and Nanoparticle transport Model in 3D geometries) is presented for the simulation of NPs injection and transport in 3D scenarios. MNM3D is the result of the integration of the numerical code MNMs (Micro and Nanoparticle transport, filtration and clogging Model - Suite) in the well-known transport model RT3D (Clement et al., 1998). The injection in field-like conditions of CARBO-IRON® (20g/l) amended by CMC (4g/l) in a 2D vertical tank (0.7×1.0×0.12m) was simulated using MNM3D, and compared to experimental results under the same conditions. Column transport tests of SLGO at a concentration (10mg/l) representative of a possible spill of SLGO-containing waste water were performed at different values of ionic strength (0.1 to 35mM), evidencing a strong dependence of SLGO transport on IS, and a reversible blocking deposition. The experimental data were fitted using the numerical code MNMs and the ionic strength-dependent transport was up-scaled for a full scale 3D simulation of SLGO release and long-term transport in a heterogeneous aquifer. MNM3D showed to potentially represent a valid tool for the prediction of the long-term behavior of engineered nanoparticles released in the environment (e.g. from landfills), and the preliminary design of in situ aquifer remediation through injection of suspensions of reactive NPs.

1 February 2022 in Science of The Total Environment
Verified
Journal Article
Closed access
MGMonica Granetto
Monica Granetto
LSLuca Serpella
Luca Serpella
SFSilvia Fogliatto
Silvia Fogliatto
LRLucia Re
Lucia Re
Carlo BiancoCarlo Bianco
Carlo Bianco
Tiziana ToscoTiziana Tosco
Tiziana Tosco

1 February 2021 in Journal of Contaminant Hydrology
Verified
Journal Article
Open access
SMSadjad Mohammadian
Sadjad Mohammadian
BKBeate Krok
Beate Krok
AFAndreas Fritzsche
Andreas Fritzsche
Carlo BiancoCarlo Bianco
Carlo Bianco
Tiziana ToscoTiziana Tosco
Tiziana Tosco
RMRainer U. Meckenstock
Rainer U. Meckenstock
Remediation of heavy metal-contaminated aquifers is a challenging process because they cannot be degraded by microorganisms. Together with the usually limited effectiveness of technologies applied today for treatment of heavy metal contaminated groundwater, this creates a need for new remediation technologies. We therefore developed a new treatment, in which permeable adsorption barriers are established in situ in aquifers by the injection of colloidal iron oxides. These adsorption barriers aim at the immobilization of heavy metals in aquifers groundwater, which was assessed in a large-scale field study in a brownfield site. Colloidal iron oxide (goethite) nanoparticles were used to install an in situ adsorption barrier in a very heterogeneous, contaminated aquifer of a brownfield in Asturias, Spain. The groundwater contained high concentrations of heavy metals with up to 25 mg/L zinc, 1.3 mg/L lead, 40 mg/L copper, 0.1 mg/L nickel and other minor heavy metal pollutants below 1 mg/L. High amounts of zinc (>900 mg/kg), lead (>2000 mg/kg), nickel (>190 mg/kg) were also present in the sediment. Ca. 1500 kg of goethite nanoparticles of 461 ± 266 nm diameter were injected at low pressure (< 0.6 bar) into the aquifer through nine screened injection wells. For each injection well, a radius of influence of at least 2.5 m was achieved within 8 h, creating an in situ barrier of 22 × 3 × 9 m. Despite the extremely high heavy metal contamination and the strong heterogeneity of the aquifer, successful immobilization of contaminants was observed in the tested area. The contaminant concentrations were strongly reduced immediately after the injection and the abatement of the heavy metals continued for a total post-injection monitoring period of 189 days. The iron oxide particles were found to adsorb heavy metals even at pH-values between 4 and 6, where low adsorption would have been expected. The study demonstrated the applicability of iron oxide nanoparticles for installing adsorption barriers for containment of heavy metals in contaminated groundwater under real conditions.

1 January 2020 in Science of The Total Environment
Verified
Journal Article
Closed access
ABAli Beryani
Ali Beryani
MMMohammad Reza Alavi Moghaddam
Mohammad Reza Alavi Moghaddam
Tiziana ToscoTiziana Tosco
Tiziana Tosco
Carlo BiancoCarlo Bianco
Carlo Bianco
Seiyed Mossa HosseiniSeiyed Mossa Hosseini
Seiyed Mossa Hosseini
RSRajandrea Sethi
Rajandrea Sethi