Water electrolysis to obtain hydrogen in combination with intermittent renewable energy resources is an emerging sustainable alternative to fossil fuels. Among the available electrolyzer technologies, anion exchange membrane water electrolysis (AEMWE) has been paid much attention because of its advantageous behavior compared to other more traditional approaches such as solid oxide electrolyzer cells, and alkaline or proton exchange membrane water electrolyzers. Recently, very promising results have been obtained in the AEMWE technology. This review paper is focused on recent advances in membrane electrode assembly components, paying particular attention to the preparation methods for catalyst coated on gas diffusion layers, which has not been previously reported in the literature for this type of electrolyzers. The most successful methodologies utilized for the preparation of catalysts, including co-precipitation, electrodeposition, sol–gel, hydrothermal, chemical vapor deposition, atomic layer deposition, ion beam sputtering, and magnetron sputtering deposition techniques, have been detailed. Besides a description of these procedures, in this review, we also present a critical appraisal of the efficiency of the water electrolysis carried out with cells fitted with electrodes prepared with these procedures. Based on this analysis, a critical comparison of cell performance is carried out, and future prospects and expected developments of the AEMWE are discussed.
28 November 2024 in Current Opinion in Electrochemistry
This manuscript reports on a Ni/Fe-based bilayer catalyst developed to boost the oxygen evolution reaction in anion exchange membrane water electrolyzers. The electrochemical behavior toward the oxygen evolution reaction of several NiFe/NiFeO metal–oxide bilayer catalysts, prepared by magnetron sputtering at oblique angle deposition (MS-OAD) on a flat stainless-steel substrate, was assessed in a three-electrode electrochemical cell in comparison with the behavior of both a metal NiFe and an oxide NiFeOx single-layer catalyst. The morphology and chemical nature of these catalysts, as prepared and after electrochemical usage, were characterized by X-ray photoelectron spectroscopy, Raman spectroscopy, Fourier transform infrared spectroscopy, and scanning electron microscopy. A thorough electrochemical characterization of the different catalyst formulations revealed a higher efficiency for the bilayer catalysts, in terms of both activity and long-term stability, and provided some clues to account for this superior performance in terms of morphology and surface reactivity of each catalyst. As a proof of concept, the best-performing bilayer configuration was then deposited onto a stainless steel felt porous transport layer (PTL) substrate and tested as an ionomer-free anode electrode in a membrane electrode assembly (MEA). Results revealed that the MS-OAD catalysts performed well when deposited on PTLs and that, under this configuration, a bilayer catalyst anode is slightly more efficient than the NiFe single-layer catalyst. Additionally, the possibility of scaling up the MS-OAD procedure to large areas has been demonstrated by the preparation of the bilayer catalysts on a 64 cm2 PTL and its successful integration and operation in a large prototype single cell.
The use of renewable energy and hydrogen technology is a sustainable solution for the intermittent feature of renewable energies. Hence, the aim of the present work is to design a self-sufficient system for a one-family house by coupling a solar photovoltaic array and an anion exchange membrane water electrolyzer (AEMWE). The first step is the selection of the photovoltaic panel by using PV-SYST 7.0 software. Then, the hydrogen production system is calculated by coupling the electrolyzer and photovoltaic panel current–potential curves. A fuel cell is selected to use the hydrogen produced when solar energy is not available. Finally, the hydrogen storage tank is also estimated to store hydrogen for a design basis of four consecutive cloudy days according to the hydrogen consumption of the fuel cell. The whole system is designed by a simple procedure for a specific location in Ciudad Real (Spain) for January, which is known as the coldest month of the year. The simple procedure described in this work could be used elsewhere and demonstrated that the hydrogen production at low scale is a suitable technology to use renewable energy for self-energy supporting in a residential application without any connection to the grid.