A resonance Raman study of graphene samples with different isotopic concentrations and using different laser excitation energies is presented. The main Raman peaks (, and ) of graphene were measured and the dependence of their frequencies on the isotope atomic mass follows a simple harmonic oscillator relation. The and double-resonance peak positions were measured as a function of the laser energy, and we observed that the slopes of the laser energy dependence are the same independently of isotope concentration. This result shows that isotopic substitution does not alter the electron and phonon dispersions near the point of the graphene Brillouin zone. From the linewidth of and Raman peaks, we have also obtained a dependence of the phonon lifetime on the isotope concentration.
Low symmetry 2D materials offer an alternative for the fabrication of optoelectronic devices which are sensitive to light polarization. The investigation of electron–phonon interactions in these materials is essential since they affect the electrical conductivity. Raman scattering probes light–matter and electron–phonon interactions, and their anisotropies are described by the Raman tensor. The tensor elements can have complex values, but the origin of this behavior in 2D materials is not yet well established. In this work, we studied a single-layer triclinic ReSe 2 by angle-dependent polarized Raman spectroscopy. The obtained values of the Raman tensor elements for each mode can be understood by considering a new coordinate system, which determines the physical origin of the complex nature of the Raman tensor elements. Our results are explained in terms of anisotropy of the electron–phonon coupling relevant to the engineering of new optoelectronic devices based on low-symmetry 2D materials.
1 November 2014 in Toxicology and Applied Pharmacology
The Raman band related to the stretching mode of hydroxyl centered at about 3650 is investigated in several natural specimens of topaz single crystals with a composition within a wide range of OH mole fractions The analysis of the OH band shape shows that its asymmetry is due to an unresolved splitting in two peaks, centered at 3639 and 3647 labeled as and respectively. Although the asymmetry is drastically different for OH-rich and OH-poor topaz, we show that this is only caused by the change of the intensity ratio with the total OH concentration. In order to explain the splitting of the OH band, we suggest a model which involves a reduction of the local symmetry from to resulting in two types of physically nonequivalent F sites and where the OH/F substitution can occur. Both sites have site symmetries and a multiplicity of 4.
21 November 2013 in Physics and Chemistry of Minerals