A method of tritium introduction into different types of organic molecules that is based on the interaction of atomic tritium with solid organic target is described. Tritium atoms are formed on the hot W-wire, which is heated by the electric current. Such an approach is called “tritium thermal activation method”. Here we summarize the results of labeling globular proteins (lysozyme, human and bovine serum albumins); derivatives of pantothenic acid and amino acids; ionic surfactants (sodium dodecylsulfate and alkyltrimethylammonium bromides) and nonionic high-molecular weight surfactants – pluronics. For the first time it is observed that if the target-compound is fixed and its radicals are stable the specific radioactivity of the labeled product can be drastically increased (up to 400 times) when the target temperature is ca. 295 K compared with the results obtained at 77 K. The influence of labeling parameters as tritium gas pressure, exposure time and W-wire temperature was tested for each target temperature that results in the optimum labeling conditions with high specific radioactivity and chemical yield of the resulting compound.
1 April 2014 in Materials Science and Engineering: C
Humic substances (HS) play important roles in the biotic-abiotic interactions of the root plant and soil contributing to plant adaptation to external environments. However, their mode of action on plants remains largely unknown. In this study the HS distribution in tissues of wheat seedlings was examined using tritium-labeled humic acid (HA) derived from leonardite (a variety of lignites) and microautoradiography (MAR). Preferential accumulation of labeled products from tritiated HA was found in the roots as compared to the shoots and endodermis was shown to be the major control point for radial transport of label into vascular system of plant. Tritium was also found in the stele and xylem tissues indicating that labeled products from tritiated HA could be transported to shoot tissues via the transpiration stream. Treatment with HA lead to an increase in the content of polar lipids of photosynthetic membranes. The observed accumulation of labeled HA products in root endodermis and positive impact on lipid synthesis are consistent with prior reported observations on physiological effects of HS on plants such as enhanced growth and development of lateral roots and improvement/repairs of the photosynthetic status of plants under stress conditions.
15 September 2010 in Applied and Environmental Microbiology
The primary goal of this paper is to demonstrate potential strengths of the use of tritium-labeled humic substances (HS) to quantify their interaction with living cells under various conditions. A novel approach was taken to study the interaction between a model microorganism and the labeled humic material. The bacterium Escherichia coli was used as a model microorganism. Salt stress was used to study interactions of HS with living cells under nonoptimum conditions. Six tritium-labeled samples of HS originating from coal, peat, and soil were examined. To quantify their interaction with E. coli cells, bioconcentration factors (BCF) were calculated and the amount of HS that penetrated into the cell interior was determined, and the liquid scintillation counting technique was used as well. The BCF values under optimum conditions varied from 0.9 to 13.1 liters kg −1 of cell biomass, whereas under salt stress conditions the range of corresponding values increased substantially and accounted for 0.2 to 130 liters kg −1 . The measured amounts of HS that penetrated into the cells were 23 to 167 mg and 25 to 465 mg HS per kg of cell biomass under optimum and salt stress conditions, respectively. This finding indicated increased penetration of HS into E. coli cells under salt stress.
Tritium labeling was introduced into detonation nanodiamonds (ND) through the tritium thermal activation method. Two target preparation techniques were developed to increase the radioactivity and the specific radioactivity of the labeled product: the desiccation of the waterless solvent suspension and the lyophilization of the hydrosol. The specific radioactivity of the labeled product was shown to correlate with the hydrogen content in the starting material and to achieve 2.6 TBq/g.