Muscle–tendon power output is commonly assessed in the laboratory through the work loop, a paired analysis of muscle force and length during a cyclic task. Work-loop analysis of muscle–tendon function in out-of-lab conditions has been elusive due to methodological limitations. In this work, we combined kinetic and kinematic measures from shear wave tensiometry and inertial measurement units, respectively, to establish a wearable system for estimating work and power output from the soleus and gastrocnemius muscles during outdoor locomotion. Across 11 healthy young adults, we amassed 4777 strides of walking on slopes from −10° to +10°. Results showed that soleus work scales with incline, while gastrocnemius work is relatively insensitive to incline. These findings agree with previous results from laboratory-based studies while expanding technological capabilities by enabling wearable analysis of muscle–tendon kinetics. Applying this system in additional settings and activities could improve biomechanical knowledge and evaluation of protocols in scenarios such as rehabilitation, device design, athletics, and military training.
Shear wave tensiometry is a noninvasive approach for assessing in vivo tendon forces based on the speed of a propagating shear wave. Wave speed is measured by impulsively exciting a shear wave in a tendon and then assessing the wave travel time between skin-mounted accelerometers. Signal distortion with wave travel can cause errors in the estimated wave travel time. In this study, we investigated the use of a Kalman filter to fuse spatial and temporal accelerometer measurements of wave propagation. Spatial measurements consist of estimated wave travel times between accelerometers. Temporal measurements are the change in wave arrival at a fixed accelerometer between successive impulsive taps. The Kalman filter substantially improved the accuracy of estimated wave speeds when applied to simulated tensiometer data. The variability of estimated wave speed was reduced by ~55% in the presence of random sensor noise. It was found that increasing the number of accelerometers from two to three further reduced wave speed errors by 45%. The use of redundant accelerometers (>2) also improved the robustness of wave speed measures in the presence of uncertainty in accelerometer location. We conclude that the use of a Kalman filter and redundant accelerometers can enhance the fidelity of using shear wave tensiometers to track tendon wave speed and loading during movement.
1 September 2023 in Journal of Sports Science and Medicine
The volleyball spike is repeated many times in practices and games, presenting a high risk of overuse injury. Previous biomechanical analyses estimating forces on the shoulder during spiking have not included the force exerted on the arm by the ball, because no practical method exists to estimate the contact force between the ball and the hand. The objective of the study was to model the internal shoulder joint reactions while including the measured ball contact force. Ten adolescent female volleyball players performed spikes while we recorded 3D motion capture data for both ball and player. Using an impulse-momentum analysis, we estimated the ball contact force, then included the force in a computational simulation model to estimate the torques produced by the shoulder. The study found that post-contact ball velocities range from 8.6 m/s - 18.2 m/s with net forces between 238 N - 672 N. Most notably, when the ball contact force was included, the average modeled internal shoulder torque to internally rotate the arm increased from -26 N-m to +44 N-m (p < 0.001). These data suggest that neglecting the contact force may risk misinterpreting connections between biomechanics and injury due to spiking. More accurate joint mechanics models will lead to better injury prevention recommendations for volleyball players of all ages.
Shear wave tensiometry is a noninvasive method for directly measuring wave speed as a proxy for force in tendons during dynamic activities. Traditionally, tensiometry has used broadband excitation pulses and measured the wave travel time between two sensors. In this work, we demonstrate a new method for tracking phase velocity using shaped excitations and measurements from a single sensor. We observed modulation of phase velocity in the Achilles tendon that was generally consistent with wave speed measures obtained via broadband excitation. We also noted a frequency dependence of phase velocity, which is expected for dispersive soft tissues. The implementation of this method could enhance the use of noninvasive wave speed measures to characterize tendon forces. Further, the approach allows for the design of smaller shear wave tensiometers usable for a broader range of tendons and applications.
1 September 2023 in Journal of Sports Science and Medicine