This work presents a study of the performance of prime mover and hydraulic implement electrification in a backhoe loader. The results are validated through simulation and experimental tests. The construction and agriculture sector has grown in recent years with the aid of compact non-road mobile machines. However, as is common in fossil fuel-powered vehicles, they significantly contribute to increasing emissions. Previous research has primarily relied on powertrain electrification to address the low-efficiency drawbacks. Notably, compact off-road vehicles comprise implements less discussed in the literature. A hybrid series topology is employed, where the rear implement is driven by an electrical drive and the Diesel engine is coupled to a generator. A rule-based energy management strategy is applied. The operation of the Diesel engine and electrical machines in optimal points of the efficiency maps are the basis of the analysis. The design is validated using simulations and experimental tests in a commercial backhoe loader as a benchmark. Experimental and simulation results obtained from the hybrid series backhoe loader applied to the hydraulic implement show a 33% reduction in fuel consumption, demonstrating the effectiveness of electrification in reducing emissions and fuel consumption of compact non-road mobile machines.
Restrictive regulations regarding emissions and fossil fuel consumption lead to the electric vehicle being an alternative to replace conventional internal combustion engine vehicles. The pure electric powertrain technology and the charging infrastructure are still immature in some markets, where increasing the overall vehicle efficiency by energy harvesting means can be a more viable solution. This paper presents the design and experimental validation of an in-wheel flux-switching machine for regenerative braking in a light passenger vehicle. Later, the energy can be used for fuel handling and reforming, performance enhancement, increasing efficiency, and reducing emissions. Feasibility and technological challenges are also discussed. The Maxwell–Fourier method and a novel steady-state equivalent circuit presented in this paper are used for geometry sensitivity analysis and optimization routine.
Micro and mild hybrid electric vehicles can make a significant contribution to reducing emissions and mitigating the environmental impact. Electric machine designs with fewer or no rare-earth permanent magnets will play an important role in the adoption of hybrid solutions. Doubly salient reluctance machines exhibit a simple structure, robust mechanical strength, excellent fault tolerance, and a wide range of speed regulation, which makes them suitable for in-wheel applications. Particular emphasis should be placed on flux-switching machines with wound-field excitation, which offer great operating flexibility, efficient heat dissipation, and power density of up to 4.8 kW/kg. This paper introduces a wound-field flux-switching machine designed for in-wheel applications, featuring individual field current control. The machine has individual access to each of the field coils. The primary objective of this research is to enhance the machine's operational versatility by enabling multiple configurations of the machine, adjusting the way the field-coils are connected. Firstly, a comparison of the armature no-load induced voltage is made for field coils connected in both series and parallel. Additionally, an assessment of the impact of open-circuit failures in one and two adjacent field coils is conducted. Finally, a current control strategy is proposed to effectively manage each individual field coil.