Large-deformation finite element (LDFE) analysis with the coupled Eulerian–Lagrangian (CEL) technique for large-deformation soil functions without twisting or distorting the mesh. However, the model does not consider the strain-softening and strain-rate dependence of clay-based soils. The undrained shear strength of clay is sensitive to the strain rate. In addition, the strain-softening effect of soil strength reduction accompanied by large-scale shear deformation should be considered. In this study, anchor dragging simulations were performed for large-deformation analysis considering strain-softening and strain-rate dependence. Furthermore, a shear strength equation expressing the strain-softening and strain-rate dependence of the Tresca constitutive model was developed based on VUMAT, an ABAQUS/Explicit subroutine. The equation was designed so that it could be linked to the LDFE/CEL model. The model was verified by performing comparative analysis with the Mohr–Coulomb (M–C) perfect-plasticity model. The newly constructed Tresca base strain-softening and strain-rate-dependence VUMAT algorithm in the LDFE/CEL model analysis confirmed the effects of strain-softening and strain-rate dependence. The proposed model enabled a highly realistic simulation of the actual phenomenon than the M–C model. Finally, a parametric study on strain-softening and strain-rate dependence was conducted, and the behavior of clay due to the anchor drag phenomenon was revealed.
31 December 2019 in Journal of Ocean Engineering and Technology
Seasonal frost or permafrost soils may encounter frost heave or thaw settlement resulting from atmospheric temperature changes and/or heat emanating from the resource-carrying pipeline. Notably, these soil movements can damage the pipeline. Thus, various ground stabilization methods have been developed to prevent the onset of these phenomena in frost-susceptible soils, and the application of thermosiphons is a representative method. Recently, a numerical analysis method called the thermosiphon model for a pipeline and thermosiphons in frost-susceptible soil has been developed; however, the study only focused on the ability to reduce frost heave of the soil using the thermosiphon. Therefore, here, numerical analysis was conducted to determine the performance of a buried pipeline according to frost heave and thaw settlement by applying the thermosiphon model via ABAQUS. For the novel numerical analysis, two scenarios are established: frost heave and thaw settlement. For each scenario, the behaviors of the frost-susceptible soil and pipeline are compared in four cases, distinguished by the arrangement of thermosiphons applied. The results indicate that according to the arrangement of the thermosiphons, the frost-heave and thaw-settlement behaviors are verifiably reduced by up to 62% and 82%, respectively, compared to when no thermosiphons are applied.
30 April 2018 in Journal of Ocean Engineering and Technology
While melting glaciers due to global warming have facilitated the development of polar routes, Arctic vessels require reliable anti-icing methods to prevent hull icing. Currently, the existing anti-icing method, i.e., the heating coil method, has disadvantages, such as disconnection and power inefficiency. Therefore, a carbon nanotube-based surface heating element method was developed to address these limitations. In this study, the numerical analysis of the surface heating element method was performed using ANSYS. The numerical analysis included conjugate heat transfer and computational fluid dynamics to consider the conduction solids and the effects of wind speed and temperature in cold environments. The numerical analysis method of the surface heating element method was validated by comparing the experimental results of the heating coil method with the numerical analysis results (under the –30 ℃ conditions). The surface heating element method demonstrated significantly higher efficiency, ranging from 56.65–80.17%, depending on the conditions compared to the heating coil method. Moreover, even under extreme environmental conditions (–45 ℃), the surface heating element method satisfied anti-icing requirements. The surface heating element method is more efficient and economical than the heating coil method. However, proper heat flux calculation for environmental conditions is required to prevent excessive design.