The IceWind turbine, a new type of Vertical Axis Wind Turbine, was proposed by an Iceland based startup. It is a product that has been featured in few published scientific research studies. This paper investigates the IceWind turbine’s performance numerically. Three-dimensional numerical simulations are conducted for the full scale model using the SST K-ω model at a wind speed of 15.8 m/s. The following results are documented: static torque, velocity distributions and streamlines, and pressure distribution. Comparisons with previous data are established. Additionally, comparisons with the Savonius wind turbine in the same swept area are conducted to determine how efficient the new type of turbine is. The IceWind turbine shows a similar level of performance with slightly higher static torque values. Vortices behind the IceWind turbine are confirmed to be three-dimensional and are larger than those of Savonius turbine.
Aerodynamics has identified remarkable development in the improvement of fuel efficiency, reducing wind noise and increasing engine cooling. Moving body profile controls fuel the consumption rate. This paper discusses a novel car profile consisting of two airfoils Roncz (car profile) and National Advisory Committee for Aeronautics NACA 10 (car sides). They are used to create a streamlined body. Three-Dimensional numerical simulations of the full scale model (half domain) are performed to examine the effect of car profile on the drag coefficient and thus fuel consumption. Simulations are considered over a range of air flow velocities, from 20 to 45 km/h in a step of 5 km/h. The ahmed body is used to validate the results. Results are shown graphically for coefficients of drag and lift and pressure and velocity contours. They show that the design of the car profile is effective.
For industrial fluid transport systems to be energy-efficient, centrifugal pumps are essential. By examining the effects of impeller shape on pumps managing trace-level oil-water emulsions (0.05% − 0.2% holdup), this study fills a major research gap. Optimizing inlet (β 1 : 10° − 30°) and output (β 2 : 20° − 30°) blade angles throughout different emulsion stability phases was the main goal. The study found a particular geometric “sweet spot” for performance improvement using integrated experimental, analytical, and numerical (Ansys CFD with SST k-ω) techniques. The uncertainty analysis for the flow rate in the experimental approach was determined to be 3.3% at a 95% confidence level. The finding that an input angle of β 1 = 20 o and an exit angle of β 2 = 30 o considerably reduces hydraulic losses with low-concentration emulsion, producing the largest head and peak efficiency, is innovative. The results also demonstrate that stable emulsions perform better than unstable ones, even when efficiency is slightly decreased by increasing concentration. These findings, which are validated by agreement across all approaches, provide practical insights for the chemical and petroleum industries, particularly for multi-phase transport, cooling systems, and lubrication optimization.
Understanding centrifugal pump local flow characteristics under different piping systems flow conditions is important. Single and two-phase flows applications via centrifugal pump are widely used in many industries. In the present work, the behavior of emulsion (oil-in-water) and air-water mixture flows through a single stage radial flow type centrifugal pump at three different pump rotation speeds has been studied experimentally and analytically. Effects of oil type, oil concentrations and air injected into the pump suction side on the pump performance under different operating conditions were considered. For each operating condition, pump discharge, generated head, efficiency and the power required to drive the pump were mainly affected by the type of oil, oil concentrations, the amount of air bubbles flowing through the pump impeller and the air injection position in the suction pipe. The results obtained from this study are valuable for chemical and petroleum industries.