Carbon coatings can help to stabilize the electrochemical performance of high-energy anodes using silicon nanoparticles as the active material. In this work, the comparison of the behavior and chemical composition of the Solid Electrolyte Interphase (SEI) was carried out between Si nanoparticles and carbon-coated Si nanoparticles (Si@C). A combination of two complementary analytical techniques, Electrochemical Impedance Spectroscopy and X-ray Photoelectron Spectroscopy (XPS), was used to determine the intrinsic characteristics of the SEI. It was demonstrated that the SEI on Si particles is more resistive than the SEI on the Si@C particles. XPS demonstrated that the interface on the Si particles contains more oxygen when not covered with carbon, which shows that a protective layer of carbon helps to reduce the number of inorganic components, leading to more resistive SEI. The combination of those two analytical techniques is implemented to highlight the features and evolution of interfaces in different battery technologies.
Sulfide‐based solid electrolytes (SEs) are amongst the most promising solid electrolytes for the development of solid‐state batteries (SSBs) due to their high ionic conductivity and processing advantage over oxide‐based SEs. However, one of the main drawbacks of sulfide SEs is their rapid degradation in presence of humidity. In this study, we investigated the effect of exposing three different sulfide SEs (Li7P3S11, the argyrodite Li6PS5Cl and the chloride‐doped argyrodite Li6‐xPS5‐xCl1+x) to the atmosphere of a dry room at a dew point (DP)=−40 °C. For the first time to the best of our knowledge, enhanced infra‐red (IR) laser technology was employed to follow and quantify online and in‐situ H2S evolution by the SEs in a dry room environment over 16 h. It was found that argyrodite compounds evolved approximately 8 times less H2S compared to Li7P3S11 over 16 h of exposure with peak concentrations between 5 and 16 ppm vol. The exposed materials were studied using X‐ray diffraction, Raman spectroscopy, electrochemical impedance spectroscopy, X‐ray photoelectron spectrometry (XPS) and galvanostatic cycling. XPS results revealed a formation of Li2CO3 on the surface of argyrodite SEs, which served as a robust passivation layer limiting considerably reactions with the dry room atmosphere.
28 September 2024 in ACS Applied Materials & Interfaces