Fabian Andres Castaño Usuga

Dr. Fabian Andres Castaño Usuga

University of Antioquia
orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 November 2022 in JMIR Medical Informatics
Verified
Journal Article
Open access
Fabian Andres Castaño UsugaFabian Andres Castaño Usuga
Fabian Andres Castaño Usuga
CGChristian Gissel
Christian Gissel
AHAlher Mauricio Hernandez
Alher Mauricio Hernandez
Background: The quest for improved diagnosis and treatment in home health care models has led to the development of wearable medical devices for remote vital signs monitoring. An accurate signal and a high diagnostic yield are critical for the cost-effectiveness of wearable health care monitoring systems and their widespread application in resource-constrained environments. Despite technological advances, the information acquired by these devices can be contaminated by motion artifacts (MA) leading to misdiagnosis or repeated procedures with increases in associated costs. This makes it necessary to develop methods to improve the quality of the signal acquired by these devices. Objective: We aimed to present a novel method for electrocardiogram (ECG) signal denoising to reduce MA. We aimed to analyze the method’s performance and to compare its performance to that of existing approaches. Methods: We present the novel Redundant denoising Independent Component Analysis method for ECG signal denoising based on the redundant and simultaneous acquisition of ECG signals and movement information, multichannel processing, and performance assessment considering the information contained in the signal waveform. The method is based on data including ECG signals from the patient’s chest and back, the acquisition of triaxial movement signals from inertial measurement units, a reference signal synthesized from an autoregressive model, and the separation of interest and noise sources through multichannel independent component analysis. Results: The proposed method significantly reduced MA, showing better performance and introducing a smaller distortion in the interest signal compared with other methods. Finally, the performance of the proposed method was compared to that of wavelet shrinkage and wavelet independent component analysis through the assessment of signal-to-noise ratio, dynamic time warping, and a proposed index based on the signal waveform evaluation with an ensemble average ECG. Conclusions: Our novel ECG denoising method is a contribution to converting wearable devices into medical monitoring tools that can be used to support the remote diagnosis and monitoring of cardiovascular diseases. A more accurate signal substantially improves the diagnostic yield of wearable devices. A better yield improves the devices’ cost-effectiveness and contributes to their widespread application.

1 December 2019 in Computer Methods and Programs in Biomedicine
Verified
Journal Article
Closed access
Fabian Andres Castaño UsugaFabian Andres Castaño Usuga
Fabian Andres Castaño Usuga
AHAlher Mauricio Hernandez
Alher Mauricio Hernandez
GSGeorges Soto-Romero
Georges Soto-Romero

29 July 2025 in Sustainability
Verified
Journal Article
Open access
PDF file
JBJuan Felipe Rodríguez Berrio
Juan Felipe Rodríguez Berrio
Fabian Andres Castaño UsugaFabian Andres Castaño Usuga
Fabian Andres Castaño Usuga
MCMauricio Andres Correa-Ochoa
Mauricio Andres Correa-Ochoa
FCFrancisco Rodríguez Cortes
Francisco Rodríguez Cortes
Julio César Saldarriaga-MolinaJulio César Saldarriaga-Molina
Julio César Saldarriaga-Molina
The Latin American and Caribbean (LAC) region faces persistent challenges of inequality, climate change vulnerability, and deteriorating air quality. The Aburrá Valley, where Medellín is located, is a narrow tropical valley with complex topography, strong thermal inversions, and unstable atmospheric conditions, all of which exacerbate the accumulation of pollutants. In Medellín, NO2 concentrations have remained nearly unchanged over the past eight years, consistently approaching critical thresholds, despite the implementation of air quality control strategies. These persistent high concentrations are closely linked to the variability of the atmospheric boundary layer (ABL) and are often intensified by prolonged dry periods. This study focuses on a representative street canyon in Medellín that has undergone recent urban interventions, including the construction of new public spaces and pedestrian areas, without explicitly considering their impact on NOx dispersion. Using Computational Fluid Dynamics (CFD) simulations, this work evaluates the influence of urban morphology on NOx accumulation. The results reveal that areas with high Aspect Ratios (AR > 0.65) and dense vegetation exhibit reduced wind speeds at the pedestrian level—up to 40% lower compared to open zones—and higher NO2 concentrations, with maximum simulated values exceeding 50 μg/m3. This study demonstrates that the design of pedestrian corridors in complex urban environments like Medellín can unintentionally create pollutant accumulation zones, underscoring the importance of integrating air quality considerations into urban planning. The findings provide actionable insights for policymakers, emphasizing the need for comprehensive modeling and field validation to ensure healthier urban spaces in cities affected by persistent air quality issues.

30 September 2024 in Physics Education
Verified
Journal Article
Closed access
Fabian Andres Castaño UsugaFabian Andres Castaño Usuga
Fabian Andres Castaño Usuga
ELEduin López
Eduin López
JJJhon Alejandro Jaramillo
Jhon Alejandro Jaramillo
VNVictor Navarro
Victor Navarro
JOJaime Osorio
Jaime Osorio
For several years, the educational gap in certain Latin American countries and around the world has become increasingly evident. The limited access to cutting-edge knowledge and technologies to strengthen student training processes has emerged as a significant problem, leading to increased inequality in job opportunities in these regions and progressive setbacks in social and economic development. One way to mitigate this problem has been to provide access to information through telecommunications. However, integration with educational processes has been deficient, especially in the areas of science, technology, engineering, and mathematics. This work proposes the development of a remote physics laboratory platform for experimental validation of models explaining certain physical phenomena. This platform is based on the Internet of Things (IoT) paradigm, allowing students and teachers to connect with these experiences coveringtopics in mechanics, electricity and magnetism, optics, and thermodynamics from remote regions. These laboratories utilize physical setups in educational institutions that have been modified to provide connectivity and remote control capabilities based on IoT. Finally, a framework for implementing new remote laboratories based on the IoT paradigm through an open-source platform is presented. The system has been tested and validated with high school and early university students to verify its usefulness, showing the potential to enhance educational processes by providing laboratory access to students and teachers from primary education to secondary education and university-level professional programs.

15 July 2021 in Sensors
Verified
Journal Article
Open access
PDF file
Fabian Andres Castaño UsugaFabian Andres Castaño Usuga
Fabian Andres Castaño Usuga
AHAlher Mauricio Hernandez
Alher Mauricio Hernandez
Wearable vital signs monitoring and specially the electrocardiogram have taken important role due to the information that provide about high-risk diseases, it has been evidenced by the needed to increase the health service coverage in home care as has been encouraged by World Health Organization. Some wearables devices have been developed to monitor the Electrocardiographic in which the location of the measurement electrodes is modified respect to the Einthoven model. However, mislocation of the electrodes on the torso can lead to the modification of acquired signals, diagnostic mistakes and misinterpretation of the information in the signal. This work presents a volume conductor evaluation and an Electrocardiographic signal waveform comparison when the location of electrodes is changed, to find a electrodes’ location that reduces distortion of interest signals. In addition, effects of motion artifacts and electrodes’ location on the signal acquisition are evaluated. A group of volunteers was recorded to obtain Electrocardiographic signals, the result was compared with a computational model of the heart behavior through the Ensemble Average Electrocardiographic, Dynamic Time Warping and Signal-to-Noise Ratio methods to quantitatively determine the signal distortion. It was found that while the Einthoven method is followed, it is possible to acquire the Electrocardiographic signal from the patient’s torso or back without a significant difference, and the electrodes position can be moved 6 cm at most from the suggested location by the Einthoven triangle in Mason–Likar’s method.

24 April 2025 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
Verified
Journal Article
Closed access
Fabian Andres Castaño UsugaFabian Andres Castaño Usuga
Fabian Andres Castaño Usuga
LRLuis Felipe Ramírez
Luis Felipe Ramírez
SMSebastian Montoya
Sebastian Montoya
DEDaniel Estrada
Daniel Estrada
JLJorge Hernán López
Jorge Hernán López